INSTALLATION & MAINTENANCE MANUAL
230V
50Hz
GU10-35w
IP
65
WALL Series
02
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products;
WALL1, WALL2, WALL3
SAFETY
• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation
• This product series is Class I and requires an earth
• This product series is IP65 rated
• This product is dimmable (subject to lamp)
INSTALLATION
• Provide power to the required point of installation. Suitable IP rated junctions boxes should be used
where required
• Using an Allen key, remove the 3 grub screws securing the base plate of the luminaire (see Fig 1)
Remove grub
screws
Fig 1
(WALL2 shown)
• Using the base plate as a template mark the location of the fixing holes, and drill the holes ensuring
not to infringe with any joists, gas or water pipes or electrical cables
• Feed mains cable through the rubber grommet to retain IP rating, and secure base plate to the
desired surface
• Ensuring correct polarity is observed, carefully wire as shown in Fig 2
Loading...