Knightsbridge UCLED4CW, UCLED4WW, UCLED7CW, UCLED7WW, UCLED9CW Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

IP

20

230V

50Hz

UCLED SERIES

60

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future

reference and maintenance.

These should be used to aid installation of the following products:

UCLED4CW/UCLED4WW/UCLED7CW/UCLED7WW/UCLED9CW/UCLED9WW/UCLED13CW/

UCLED13WW/UCLED18CW/UCLED18WW/UCLED22CW/UCLED22WW

SAFETY

• Installation of this luminaire should only be carried out by a qualified electrician or competent

person to the current building and IEE Wiring Regulations (BS7671)

• Before installation/maintenance, ensure that all mains supply to the luminaire is switched off and

the circuit fuses are removed or switched off

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the

rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this luminaire

when deciding the location for installation

• This product is class II double insulated

• Please recycle this unit

• This product is non-dimmable

• This product is IP20

INSTALLATION

Note - If this luminaire is being used in conjunction with external PIR or sensors, please confirm with

the manufacturer of the sensors that they are compatible with LED luminaires.

• Provide a suitable power supply to the required position of the luminaire, and then connect the

supplied mains cable with the ‘figure of 8’ connector

• Mark the location of the fixing holes for the mounting clips. The mounting clips should be spaced

so as to distribute the weight of the luminaire evenly. Drill the holes for the mounting clips (see fig

1) ensuring not to infringe with any joists, gas/water pipes or electrical cables that may be hidden

behind the surface

Note: The 4W, 7W and 9W units only require two mounting clips and the 13W, 18W and 22W versions

require three.