Knightsbridge UCLED4CW, UCLED4WW, UCLED7CW, UCLED7WW, UCLED9CW Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

UCLEDxxx

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
UCLED4CW / UCLED4WW / UCLED7CW / UCLED7WW / UCLED9CW / UCLED9WW / UCLED13CW /
UCLED13WW / UCLED18CW / UCLED18WW / UCLED22CW / UCLED22WW

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product is for indoor use only

• This product is Class II double insulated

• This product series is IP20 rated

INSTALLATION

Note - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation

• Mark the location of the fixing holes for the mounting clips and drill ensuring not to infringe with any gas /
water pipes or electrical cables. The mounting clips should be spaced to distribute the weight of the luminaire
evenly. The 4W – 9W units are provided with two mounting clips, the 13W – 22W versions are provided with
three (see Fig. 1)