Knightsbridge TRLED14EM, TRLED15EM, TRLED15EMD, TRLED16EM, TRLED16EMD Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

TRLED14EM / TRLED15EM
TRLED15EMD / TRLED16EM
TRLED16EMD / TRLED24EM
TRLED25EM / TRLED25EMD
TRLED26EM / TRLED26EMD

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
TRLED14EM / TRLED15EM / TRLED15EMD / TRLED16EM / TRLED16EMD / TRLED24EM
TRLED25EM / TRLED25EMD / TRLED26EM / TRLED26EMD

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product is Class I and must be earthed

• This product is IP65 rated

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable IP
rated junction boxes should be used where required

• Using the mounting brackets as a template, mark the location for, and drill the fixing holes ensuring not to
infringe with any gas/water pipes or electrical cables. Fixing centres are shown in Fig. 1

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of

the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product is Class I and must be earthed

• This product is IP65 rated

INSTALLATION

Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required

• Using the mounting brackets as a template, mark the location for, and drill the fixing holes ensuring not

to infringe with any gas/water pipes or electrical cables. Fixing centres are shown in Fig. 1

Fig. 1

• Secure the mounting brackets to the surface using suitable fixings (not included)

• Unfasten the clips on either side of the fitting (see Fig. 2)

(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

the circuit cable, fuse or circuit breaker

Suitable IP rated junction boxes should be used where required

to infringe with any gas/water pipes or electrical cables. Fixing centres are shown in Fig. 1

Fig. 1

• Secure the mounting brackets to the surface using suitable fixings (not included)

• Unfasten the clips on either side of the fitting (see Fig. 2)

Fig. 2