Knightsbridge T8BLED26EM, T8BLED26HLEM, T8BLED15EM, T8BLED16EM, T8BLED15HLEM Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

IP

20

230V

50Hz

T8BLED EM SERIES

52

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future

reference and maintenance.

These instructions should be used to aid installation of the following products:

T8BLED15EM, T8BLED15HLEM, T8BLED16EM, T8BLED16HLEM, T8BLED25EM, T8BLED25HLEM,

T8BLED26EM, T8BLED26HLEM

SAFETY

• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation

• This product is Class I and requires an earth

• This product is non-dimmable

INSTALLATION

• Provide power to the required point of installation

• Remove the end caps with the aid of a slotted screwdriver

• Remove 2 screws on top of the twin fitting (see fig 1)

End
Cap

Fig 1 Twin fitting

Remove screws

• Remove the LED plate on the single version by pinching together under the LED plate

• Slide the LED plate off on the twin version

• Mark the location of the fixing holes and drill the holes ensuring not to infringe with any joists,
gas or water pipes or electrical cables

• Bring power cable into luminaire

• Secure luminaire to ceiling

• Connect the permanent live, neutral, earth and switched live to the push fit terminals on the
terminal block (see fig 2)