Knightsbridge T8BLED15, T8BLED25, T8BLED14, T8BLED16, T8BLED16HL Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

IP

20

230V

50Hz

T8BLED SERIES

52

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future

reference and maintenance.

These instructions should be used to aid installation of the following products:

T8BLED12, T8BLED14, T8BLED15, T8BLED15HL, T8BLED16, T8BLED16HL, T8BLED22, T8BLED24,

T8BLED25, T8BLED25HL, T8BLED26, T8BLED26HL

SAFETY

• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the current Building and IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation

• This product is Class I and requires an earth

• This product is non-dimmable

INSTALLATION

• Provide power to the required point of installation

• Remove the end caps with the aid of a slotted screwdriver

• Remove 2 screws on top of the twin fitting (see fig 1)

End
Cap

Fig 1 Twin fitting

Remove screws

• Remove the LED plate on the single version by pinching together under the LED plate

• Slide the LED plate off on the twin version

• Mark the location of the fixing holes and drill the holes ensuring not to infringe with any joists,
gas or water pipes or electrical cables

• Bring the power cable into the luminaire

• Secure luminaire to the ceiling

• Connect the live, neutral and earth to the push-fit terminals on the terminal block (see fig 2)

Live (brown)

Ear

th (yellow/green)

Neutral (blue)

Fig 2

• Check the earth tab connection is still in place and reconnect if required

ALTERNATIVE POWER SUPPLY METHOD

• The end cap can be drilled out (20mm drill bit) and a 20mm compression gland (not included) can
be used (see fig 3)

Fig 3

20mm drill bit
required to cut
out a hole for the
compression gland.

WARNING

This product must be disconnected from the circuit if it subjected to any high voltage or insulation
resistance testing. Irreparable damage will occur if this instruction is not followed

GENERAL

The LEDs fitted in this product are non-replaceable. The unit should be recycled in the correct
manner when it reaches the end of its life. Check local authorities for where facilities exist.

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may
damage the fitting.

WARRANTY

This product has a warranty of 5 years from date of purchase. Failure to install this product in
accordance with the current edition of the IEE Wiring Regulations, improper use, or removal of
the batch codes will invalidate the warranty. If this product should fail within its warranty period it
should be returned to the place of purchase for a free of charge replacement. ML Accessories does
not accept responsibility for any installation costs associated with the replacement product. Your
statutory rights are not affected. ML Accessories reserve the right to alter product specification
without prior notice.

ML Accessories Limited
LU5 5TA

www.mlaccessories.co.uk

SBDEC16_V3