Knightsbridge SKR008, SKR009A Installation Manual

INSTALLATION & MAINTENANCE MANUAL

SKR008 / SKR009A

230V

50Hz

IP

20

11

1

GENERAL INSTRUCTIONS

SKR008 & SKR009

Remove screws

SKR008 & SKR009

Fig 1

Remove screws

Screw mounting locations

Cable entry
gland

These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
SKR008 / SKR009A

SAFETY

• Installation of this product should only be carried out by a qualified electrician or competent person
to the latest Building and current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this product is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker

• This product is Class I and must be earthed

• For indoor use only

• Do not subject product to insulation resistance testing

INSTALLATION

• Provide power to the required point of installation

• Remove the two screws on the front plate to remove the plate (see Fig 1)

Fig 1

• Mark the location of the fixing holes and drill the holes ensuring not to infringe with any joists,
gas/water pipes or electrical cables (see Fig 2)

Fig 2

2