Knightsbridge SFCARDAT, SFCARDBN, SFCARDBC, SFCARDMB, SFCARDMW Installation Instructions

These instructions should be read carefully and retained after
installation by the end user for future reference and maintenance.
These instructions should be used to aid installation of the
following product: SFCARDxx

SAFETY

• This product must be installed in accordance with the latest
edition of the IEE Wiring Regulations (BS7671) and current
Building Regulations. If in any doubt, consult a qualified
electrician

• Please isolate mains prior to installation or maintenance

• Please note the IP (Ingress Protection) rating of this product
when deciding the location for installation

• Do not overload this accessory or subject it to conditions outside
its rating

• This product is Class I and must be earthed

• This product is IP20 rated

INSTALLATION

• Provide power to the required point of installation

• Remove the front cover with the aid of a slotted screwdriver

(see Fig. 1)

Fig. 1

• Ensuring correct polarity is observed, carefully wire as shown in
Fig. 2

Fig. 2

• Remove the card holder and secure the product to the back box
(see Fig. 3)

Fig. 3

• Replace the card holder and front cover

• Switch on and check for correct operation

WARNING

This product must be disconnected from the circuit if subjected
to any high voltage or insulation resistance testing. Irreparable
damage will occur if this instruction is not followed.

GENERAL

This product should be recycled in the correct manner when
it reaches the end of its life. Check local authorities for where
facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning
products or solvents which may damage the product.

WARRANTY

This product has a warranty of 3 years from date of purchase.
Failure to install this product in accordance with the current
edition of the IEE Wiring Regulations (BS7671), improper
use, or removal of the batch code will invalidate the warranty.
If this product should fail within its warranty period, it should
be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for
any installation costs associated with the replacement product.
Your statutory rights are not affected. ML Accessories reserve the
right to alter product specification without prior notice.

AVOCT21_V2

ML Accessories Limited
LU5 4LT

www.mlaccessories.co.uk

11