INSTALLATION & MAINTENANCE MANUAL
IP
65
230V
50Hz
RW6 Series
118
1
GENERAL INSTRUCTIONS
RW6 Series
competent person to the latest Building and current IEE Wiring Regulations (BS7671)
exceed the rating of the circuit cable, fuse or circuit breaker
location for installation
be used where required
infringe with electrical cables, water/gas pipes or ceiling joists
72mm
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
RW6WW / RW6CW / RW6CCT
SAFETY
• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation
• If used under insulation, the insulation should be laid unbroken over the luminaire
(not packed around it). Only mineral wool style insulation may be used
• This product is Class I and must be earthed
• This product is dimmable with most trailing edge dimmers
• This product is IP65 rated
INSTALLATION
Note: If this luminaire is being used in conjunction with external PIR or sensors, please confirm with
the manufacturer of the sensors that they are compatible with LED luminaires.
• Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
• Cut a suitable hole in the ceiling as per the cut-out details in Fig 1 ensuring that it does not infringe
with electrical cables, water/gas pipes or ceiling joists
Fig 1
2
Loading...