Knightsbridge PWL8 Installation Instructions

WARRANTY

This product has a warranty of 2 years from date of purchase. Failure to install this product in accordance with
the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve
the right to alter product specification without prior notice.

SUPPLIED BY:

ML ACCESSORIES LTD, UNIT E CHILTERN PARK,

BOSCOMBE ROAD, DUNSTABLE LU5 4LT,

230V

(UK) MANUFACTURER

WWW.MLACCESSORIES.CO.UK

(EU) AUTHORISED REPRESENTATIVE

SLV LIGHTING GROUP,

DAIMLERSTRASSE 21-23,

52531 ÜBACH-PALENBERG, GERMANY

EMAIL: [e-mail]

MADE IN CHINA

IP20

50Hz

141

INSTALLATION & MAINTENANCE MANUAL

PWL8

JBSEP23_V1

PWL8 INSTRUCTIONS_SPREADS.indd 1-3PWL8 INSTRUCTIONS_SPREADS.indd 1-3 13/10/2023 14:53:5713/10/2023 14:53:57

INSTALLATION & MAINTENANCE MANUAL

(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

the circuit cable, fuse or circuit breaker

infringe with any gas/water pipes or electrical cables

E – Earth (green/yellow), N – Neutral (blue)

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
PWL8

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product should be installed in the upright position

• This product is for indoor use only

• This product is Class I and must be earthed

• This product is IP20 rated

INSTALLATION

• Provide power to the required point of installation

• Using the mounting plate as a template, mark the location for, and drill the fixing holes ensuring not to
infringe with any gas/water pipes or electrical cables

• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L – Live (brown), E –
Earth (green/yellow), N – Neutral (blue)

Fig. 1

• Fix the mounting plate to the wall using screws and wall plugs provided (see Fig. 1)

• Hook the body of the luminaire onto the mounting plate and screw in the threading on either side of the
mounting plate into the body of the luminaire with the alan key provided

• Insert a suitable lamp to lamp holder (see Fig. 2)

Fig. 2

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.
This product is dimmable dependent on lamp type.
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.

PWL8 INSTRUCTIONS_SPREADS.indd 4-6PWL8 INSTRUCTIONS_SPREADS.indd 4-6 13/10/2023 14:53:5713/10/2023 14:53:57