Knightsbridge PWL2, PWL1 Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

PWL1 / PWL2

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the
end user for future reference and maintenance.
These instructions should be used to aid installation of the following products:
PWL1 / PWL2

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring
Regulations (BS7671) and current Building Regulations. If in any doubt, consult a
qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not exceed
the rating of the circuit cable, fuse, or circuit breaker

• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location
for installation

• This product is for indoor use only

• This product is Class I and must be earthed

• This product series is IP20 rated

(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

the circuit cable, fuse, or circuit breaker

installation

infringe with any gas/water pipes or electrica l cables

L - Live (Brown), E - Earth (Green/Yellow), N - Neutral (Blue)

INSTALLATION

• Provide power to the required point of installation

• Using the mounting plate as a template, mark the location for, and drill the fixing holes
ensuring not to infringe with any gas/water pipes or electrical cables

• Connect the luminaire to the mains supply ensuring the correct polarity is observed
(see Fig. 1): L - Live (Brown), E - Earth (Green/Yellow), N - Neutral (Blue)

Fig.1

• Fix the mounting plate to the wall using the screws and wall plugs provided (see Fig. 1)

• Insert a suitable G9 lamp and slide the body of the luminaire into the mounting plate
(see Fig. 2)

Fig.2

• Switch on and check for correct operation

GENERAL

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which
may damage the product.
This product is dimmable dependent on lamp type.
This product should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist.

WARRANTY

This product has a warranty of 2 years from date of purchase. Failure to install this product
in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper
use, or removal of the batch code will invalidate the warranty. If this product should fail
within its warranty period, it should be returned to the place of purchase for a free of
charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.

141

AKMAY21_V1