Knightsbridge OS006 Installation & Maintenance Manual

1

85

INSTALLATION & MAINTENANCE MANUAL

OS006

IP

55

230V

50Hz

2

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following product:

OS006

GENERAL INSTRUCTIONS

SAFETY

INSTALLATION

• Installation of this product should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this product and load is fitted) does not exceed
the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this product when deciding the location for
installation

• This unit is rated at IP55

• This product is Class I and must be earthed

Note: Avoid mounting this product in direct sunlight and

near luminaires as this could cause nuisance tripping

• Provide power to the required point of installation

• Remove the 4 screws that secure the front cover

• Using the base as a template mark the 4 fixing holes

• Ensuring not to infringe with any gas/water pipes or

electrical cables, drill the 4 holes and secure the sensor
base using the fixings provided (see Fig 1)

Fig 2

OS006

• Insert the mains and lighting cables into the sensor via the rubber grommets on the back of the
sensor ensuring the IP rating of this product is maintained (silicon sealant may be required)

Ensuring correct polarity is observed:

• terminate the mains supply - brown (L), blue (N) and yellow/green

• terminate the lighting cables - brown ( ), blue (N), yellow/green
(see Fig 2)

Fig 1

EARTH