Knightsbridge OP5GBK, OP3GBK Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.

These instructions should be used to aid installation of the following products:

IP3G / IP5G / OP3GBK / OP5GBK

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• Do not overload this accessory or subject it to conditions outside its rating

• This product is Class I and must be earthed

• This product is IP66 rated

INSTALLATION

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable
IP rated junction boxes should be used where required

• Round cable should be used for the mains supply and connected loads. The use of flat cable will cause
water ingress

• Remove the fixing screws securing the front cover

• Drill the fixing holes in the rear of the box. Mark the location of the fixing holes and drill ensuring not to

infringe with any gas/water pipes or electrical cables

• Fix the box to a solid surface using suitable screws and wall plugs (not included). The output compression
glands should be facing downwards

• Refit the screw mounting hole caps (failure to fit these caps will compromise the IP rating)

• Unscrew the sealing nut from the compression gland (see Fig. 1) and fit it over the supply cable

Output 1 Output 2 Output 3 Output 4 Output 5

IP3G / OP3GBK 8A 2.5A 2.5A - -

IP5G / OP5GBK 5A 2.5A 2.5A 2A 1A