INSTALLATION & MAINTENANCE MANUAL
230V
50Hz
IP
54
LANT1x / LANT2x
02
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
LANT1 / LANT1W / LANT2 / LANT2W
SAFETY
• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this luminaire when deciding the location for
installation
• This product is Class II double insulated
• This product is non-dimmable
• This product is IP54 rated
INSTALLATION
• Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
• Remove the 2 nuts on the front of the fitting securing the baseplate of the luminaire
• Using the baseplate as a template mark the location of the fixing holes, and drill the holes ensuring
not to infringe with any joists, gas or water pipes or electrical cables
• Feed mains cable through the rubber grommet to retain IP rating and secure baseplate to the
desired surface. Carefully wire as shown in Fig 1
• Reassemble ensuring there are no trapped cables
• Switch on and check for correct operation
Neutral (blue)
Live (brown)
Fig 1
Loading...