Knightsbridge FLRxxP series, FLR10P, FLR20P, FLR30P, FLR50P Installation & Maintenance Manual

1

INSTALLATION & MAINTENANCE MANUAL

FLRxxP

IP

65

230V

50Hz

42

2

These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
FLR10P/FLR20P/FLR30P/FLR50P

GENERAL INSTRUCTIONS

SAFETY

INSTALLATION

• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this load is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this product when deciding the location for
installation

• This product series is IP65 rated

• This product is Class I and must be earthed

• This product is non-dimmable

• Outdoor electrical installations should be protected by an earth leakage circuit breaker such as a
residual current device (RCD). This will cut the power supply should it detect a leakage of current
to earth which is potentiality dangerous

• Provide power to the required point of installation

• This product has an angled bracket for ease of
installation and does not need to be removed
(see Fig 1)

Fig 2

Fig 1

FLRXX

• Installation of this driver should only be carried out by a qualified electrician or competent person to the
latest Building and current IEE Wiring Regulations (BS7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this load is fitted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this product when deciding the location for installation

• This product series is IP65 rated

• This product is Class I and must be earthed

• This product is non-dimmable

• Provide power to the required point of installation

• Using the angled bracket as a template, mark the location of the fixing holes and drill the holes ensuring not to

infringe with any gas/water pipes or electrical cables

• Remove the four screws on the access plate at the rear of the fitting to expose the terminal block (see Fig 1)

Screws

• Using the angled bracket as a template, mark
the location of the fixing holes, and drill the holes
ensuring not to infringe with any gas/water pipes
or electrical cables

• Remove the four screws on the access plate at the
rear of the fitting to expose the terminal block
(see Fig 2)