Knightsbridge EASPK1W, EASPK1BK, EASPK1BB, EASPK1A Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

EASPK1xx

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the
end user for future reference and maintenance.

These instructions should be used to aid installation of the following product:
EASPK1xx

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring
Regulations (BS7671) and current Building Regulations. If in any doubt, consult a
qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this luminaire is fitted) does not
exceed the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location
for installation

• This product is Class II double insulated

• This product is IP65 rated

INSTALLATION & MAINTENANCE MANUAL

INSTALLATION

• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required

• The power source connections should be local and accessible via a suitable IP rated
enclosure

• Choose a position for the luminaire ensuring the ground is suitable to firmly hold the
spike and luminaire in position. Check the ground is not liable to flooding and the spike
does not infringe with any underground pipes or cables

• The body of the product should not rest directly on the ground

• The pre-installed cable supplied is for above-ground use only. Cables that are to be
routed within walls or below ground must be protected by means of suitable conduit or
trunking (see Fig. 1)

Fig. 1

• Connect the luminaire to the mains supply ensuring the correct polarity is observed:
Live (brown), Neutral (blue)

• Unscrew the bezel, insert a suitable LED lamp (5W max.) and carefully replace the bezel
ensuring that the seal is in place and not damaged

• Switch on and check for correct operation

GENERAL

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm
water only, do not use aggressive cleaning products or solvents which may damage the
product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

This product is dimmable dependent on lamp type.

The external supply cable of this luminaire cannot be replaced; if the cable is damaged, the
luminaire should be destroyed

This product should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist.

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product
in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper
use, or removal of the batch code will invalidate the warranty. If this product should fail
within its warranty period, it should be returned to the place of purchase for a free of
charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.

Supplied By:

ML Accessories Ltd, Unit E Chiltern Park, Boscombe Road,

Dunstable LU5 4LT, www.mlaccessories.co.uk

nnuks Holding GmbH, Niederkasseler Lohweg 18, 40547

(UK) Manufacturer

(EU) Authorised Representative

Düsseldorf, Germany, www.nnuks.com

Email: [e-mail]

02

DCMAR22_V1