Page 1
INSTALLATION & MAINTENANCE MANUAL
24DC100M / 24DC150M /
24DC200M
Page 2
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
24DC100M / 24DC150M / 24DC200M
SAFETY
• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the
circuit cable, fuse, or circuit breaker
• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
• Allow 50mm above and around the fitting for air dissipation (do not cover the fitting with insulation)
• Do not overload this accessory or subject it to conditions outside its rating
• This product is for indoor use only
• This product must be placed inside a suitable enclosure
• This product is Class I and must be earthed
• This product is IP20 rated
INSTALLATION
• Provide power to the required point of installation
• Mount the driver in a suitable vented enclosure ensuring there is adequate space around and above the
product for heat dissipation
• Connect to the mains supply ensuring the correct polarity is observed (see Fig. 1): L – Live (brown),
E – Earth (green/yellow), N – Neutral (blue)
Page 3
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
the circuit cable, fuse, or circuit breaker
the product for heat dissipation
E – Earth (green/yellow), N – Neutral (blue)
24DC100M /
24DC150M
the circuit cable, fuse, or circuit breaker
the product for heat dissipation
E – Earth (green/yellow), N – Neutral (blue)
24DC100M /
24DC150M
24DC200M
24DC100M / 24DC150M
24DC200M
Fig.1
• Switch on and check for correct operation
This driver is equipped with an output voltage adjuster (+V ADJ) which can increase or decrease the output
voltage by approximately 10%. No adjustment should be necessary, but should the driver be loaded to its total
capacity the voltage can be trimmed to help prevent overload; alternatively increasing the output voltage can
help to compensate for voltage drop on the load side.
Page 4
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
GENERAL
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.
The maximum constant ambient temperature at the point of installation should not exceed 50°C.
This product is non-dimmable.
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.
Page 5
WARRANTY
This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with
the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve
the right to alter product specification without prior notice.
Page 6
INTERNATIONAL
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
CONTACT DETAILS
ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
134
DCNOV21_V1
Loading...