Knightsbridge 1050DALI45W Installation Instructions

INSTALLATION & MAINTENANCE MANUAL

1050DALI45W

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
1050DALI45W

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• Allow 50mm above and around the fitting for air dissipation (do not cover with insulation)

• Do not overload this accessory or subject it to conditions outside its rating

• This product is for indoor use only

• This product is Class II double insulated

• This product is IP20 rated

INSTALLATION

• Provide power to the required point of installation.

• Remove the terminal cover by inserting a screwdriver on each side of the cover and gently prying it open.

• Using the DIP switches, please set the current of the driver to match the load connected to it,

see Fig. 1 for DIP switch layout and luminaires compatible.

Fig. 1

Product Current

LUMI6060PRODALI 800mA

SER1525DALI 350/500/600mA

SER3040DALI 700/800/900mA

SA1525CDALI 350/500/600mA

SA3040CALI 700/800/900mA

SA3040RWDALI 700/800/900mA

• Ensuring correct polarity is observed, carefully wire as shown in Fig. 2

Fig. 2

• Connect a suitable LED load to the secondary side of the driver.

• Ensure that the cable strain relief is securing the cables effectively.

• Reattach the terminal cover.

• Switch on and check for correct operation.

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.
This product is DALI control compatible. Relevant DALI software and control gear is required for use of this
functionality.
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.

WARRANTY

This product has a warranty of 5 years from date of purchase. Failure to install this product in accordance with
the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve
the right to alter product specification without prior notice.

SUPPLIED BY:

ML ACCESSORIES LTD, UNIT E CHILTERN PARK,

BOSCOMBE ROAD, DUNSTABLE LU5 4LT,

(UK) MANUFACTURER

WWW.MLACCESSORIES.CO.UK

(EU) AUTHORISED REPRESENTATIVE

SLV LIGHTING GROUP,

DAIMLERSTRASSE 21-23,

52531 ÜBACH-PALENBERG, GERMANY

EMAIL: [e-mail]

MADE IN CHINA

IP20

-20~

+50

TA

59

AVNOV23_V1