Knight Electronics LQSQ5 User Manual

Wireless remote control operation instruction

Product introduction

1.1 The appearance and buttons

Figure 1. The remote control appearance

As shown in figure 1, the remote control has four separate

button, from left to right are respectively

Followed by mode conversion button, horn button, unlock

button, switch button.

1.2 Product function is introduced

1

（I）Lock unlock: if the car is locked, original click ，The

car unlocked. If the car is not locked, original click ，car lock.

（II）Unlock: original click ，The car unlocked. If the

original is not locked, also can't lock the button press a few

times, it is pure unlock button. with button press can trigger

the calibration function. (In the calibration status, keep the car

pedal parallel to the ground.

)

（III）Calibration profile: At the same time hold down the

，There will be 1 of "di ~", until the tail lights flash

began to seconds. The current profile data was successfully

saved, switch the power button again.

（IIII）Buzzer: hold down the ，The car alarm, horn of

nights.

（IV）Mode switch: press ，From the two modes to switch

back and forth. Electricity low sensitive mode by default.

When the car balance total power, balance the car hasn't

been used, automatically turn off the power supply in an hour.

Total power switch is not open the remote control doesn't work.

2