K'Nex COLLECT & BUILD RACECAR RALLY, COLLECT & BUILD FORMULA CAR Series Manual

BUILDING BASICS

Start Building

To begin your model, find the and follow the numbers. Each piece has its own shape and color. Just look at the pictures, find the pieces in your set that match and then connect them together.

Try to face your model in the same direction as the instructions while you build. Faded colors show you this section is already built. You’ll want to connect the new section to the place where the arrows are pointing.

Connectors

There are blue and gray Connectors with special long slots. They slide together as you see in the pictures. Push these parts together until you hear a “click.”

1 2

K’NEX Brick Separator Tool

BATTERY INFORMATION

Caution: To Avoid Battery Leakage

• Be sure to insert the batteries correctly and always follow the toy

and battery manufacturers’ instructions.

• Do not mix old and new batteries or alkaline, standard (carbon-zinc)

or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type recommended should be used.

• Always remove weak or dead batteries from the product; do not

short-circuit supply terminals.

• Insert batteries with correct polarity (+/-) as shown.

Important Tips

• Alkaline batteries AA (LR6) are recommended.

• Rechargeable batteries are not recommended.

• Remove rechargeable batteries from toy before charging; they must

be charged only under adult supervision.

• Non-rechargeable batteries must not be recharged.

• Keep components free of dust; do not immerse or use in water.

• Do not dispose of batteries in a fire; they could leak or explode and

cause injury.

• Remove all batteries if the toy will not be used for a long period of time.

• Do not put Rods smaller than 2 inches in any openings of the motor;

they will damage the motor, and cannot be removed.

How to Insert and Remove Batteries

Use a small Phillips head screwdriver to loosen the screw. Insert 2 fresh AA batteries (LR6) into the compartment with the correct polarity (+/-) as shown here.

The motor has 2 switches

• One to control the motor.

• The other engages the motor gears.

Use this motor switch to run the motor forward or backward.

Always push this gear switch to the left before you turn on the motor.

–

• Push the motor switch to the left to

make your model move forward.

• Push the motor switch to the right to

make your model move backwards.

• Push the motor switch to the middle

to turn off the motor.

• Use the gear switch to disengage the

motor gears, then you can push the model and the wheels will spin without the motor running.

• Always turn the motor switch off

before you disengage or engage the gear switch.

PARTS LIST

Before you start building, be sure to compare the parts in your set with the parts listed here.

If anything is missing, call or write to us using the information on the back cover. We are happy to help you!

Figure Assembly

for Instruction UpdatesGo to

Did you install 2 AA (or LR6) batteries in the Motor?

Est-ce que tu as installé 2 piles AA (ou LR6) dans le moteur ?

¿Instalaste dos pilas AA (o LR6) en el Motor?

Heb je 2 AA (of LR6) batterijen gestoken in de motor?

Hai installato 2 batterie AA (o LR6) nel motore?

Foram instaladas as pilhas 2 AA (ou LR6) no Motor?

Heb je er 2 AA (of LR6) batterijen ingestoken?

Installerade du 2AA (eller LR6) batterier?

Har du sat 2 AA (eller LR6) batterier i?

Har du installert 2AA (eller LR6) batteriene?

Oletko asentanut 2AA (tai LR6) -paristot?

1 2

1 3

1 6

1 9