KMC Controls STE-1430 User Manual

Room Temperature Sensor (Flat Plate)

Installation Guide

Mounting and Wiring

The STE-1430 is a blank, stainless-steel wall plate
that incorporates a precision sensor used to monitor
room temperatures where additional security is
required (e.g., against vandalism).

It is designed to be mounted directly to a single-gang
electrical box. Insulating foam is adhered to the back
of the wall plate to provide a thermal barrier from
internal wall temperatures. The STE-1430 should
be installed where it can sense the average room

temperature and be unaected by direct sunlight

and drafts.

STE-1430

1. Feed the cable wires through the conduit or hole
opening.

2. Make connections to the two sensor wire leads
with either bu-splices or solder. (Using wire
nuts is not recommended.) The two-wire sensor
is not polarity sensitive.

3. Plug the conduit with plumber’s puy, painter’s
puy, caulk, or other sealant to prevent air
inltration.

4. Aach the sensor panel to the electrical box using

the two supplied #6 screws.

Configuration

For controller conguration, see the Type III Sensors

Applications Guide on the KMC web site.

Specifications

0.1875"

4.75 mm

3.375"

85.73 mm

4.5"

114.3 mm

2.75"

69.85 mm

Sensor Type III thermistor, 10K ohm

@ 77° F (25° C)

Temperature Limits –4 to 221° F (–20 to 105° C)

Wiring 22 AWG wire leads

Dimensions 2-3/4 x 4-1/2 inches (70 x 114

mm)

Finish Brushed stainless steel

STE-1430 1 Installation Guide

Maintenance

No routine maintenance is required. Each compo­nent is designed for dependable, long-term reliability
and performance. Careful installation will also
ensure long term reliability and performance.

More Information

Important Notices

For additional information,
see the STE-1400 Series

Data Sheet on the KMC

web site.

For troubleshooting, con-

troller conguration, and

other information, see the

Type III Sensors Applica­tions Guide on the KMC

web site.

The KMC logo and KMC Controls are registered
trademarks of KMC Controls, Inc.

All rights reserved. No part of this publication may

be reproduced, transmied, transcribed, stored in a

retrieval system, or translated into any language in
any form by any means without the wrien permis­sion of KMC Controls, Inc.

The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.

KMC Controls, Inc.

19476 Industrial Drive

New Paris, IN 46553

574.831.5250

www.kmccontrols.com

[e-mail]

STE-1430 2 Installation Guide© 2014 KMC Controls, Inc. 717-019-20B