KMC Controls REE–2004 User Manual

Solid State Relay Modules

Installation Guide

Mounting

• The REE–2004 may be mounted directly to a control panel backplate surface.

• No heat sink is required for loads up to 4 amperes. Loads greater than 4 amperes

require a heat sink and thermal pad.

REE–2004

Wiring

Connect input directly to the DC output of the KMC
controller. The load may connect to either Terminal
1 or Terminal 2.

Maintenance

No routine maintenance is required. Each
components design and material selection assures
long-term reliability and performance. Careful
installation and proper heat sinking will enhance
long term reliability and performance.

HPO-4611 Heat Sink

KMC Controls

19476 Industrial Drive

New Paris, IN 46553

TEL: [phone]
FAX: [phone]

www.kmccontrols.com

717-019-36