KMC Controls MEP-1500 Series Installation Manual

Installation Guide

Required Tools

• digital voltmeter

• small phillips screwdriver

• small flatblade screwdriver

• 5/16" Allen wrench

Mounting

1. Set the MEP–1500 in the desired location.

2. Slide the MEP–1500 unit directly on to the
standard 1/2" diameter (13 mm) damper shaft.
See below for adaptor directions.

3. Tighten the two (2) 5/16"–18 set screws (see
diagram)

Rotary Electric Actuator

MEP–1500 Series

MEP–1500

Side View

4. Place the non-rotation bracket (supplied) on the
non-rotation tab.

5. Attach the anti-rotation bracket to the mounting
surface using #8 or #10 self tapping screws (not
included)

How to use the HFO-0011 Adaptor

1. Mount the MEP–1500 actuator over the 3/8 " shaft

2. Slide the HFO-0011 over the shaft into the drive
bushing of the actuator.

3. Align the adaptor slots with the set screws

4. Tighten the set screws.

Wiring

• Wire to “CW”, “CCW” and COM terminals as
appropriate.

• DO NOT remove motor leads from terminals and
wire directly to the motor.

• DO NOT connect power directly to motor unless a
terminal strip is used.

HFO-0011 Adaptor

MEP–1500: Wiring Detail

Maintenance

No routine maintenance is required. The motors are permanently lubricated and all internal gear-train
component are oil-impregnated. Careful installation will also ensure long term reliability and performance.

KMC Controls

P.O. Box 497

19476 Industrial Drive

New Paris, IN 46553

U.S.A.
TEL: [phone]
FAX: [phone]

E-mail: [e-mail]

020-019-01B