KMC Controls HLO-1020 User Manual
Crank Arm Kit for MEP-7000 Series Actuators
Installation Guide
HLO-1020
Mounting
1. From the MEP-7xxx actuator, remove and discard
the V-bolt.
2. Assemble and install the kit and actuator as
shown in the diagram below.
NOTE: In general, position both the ball joints
as close to the end of the crank arms as is
feasible for the application. Positioning a
ball joint in the slot closer to the shaft will
change the torque, rotation speed, and/or
angle of rotation—which may be useful for
some applications.
NOTE: Check for potential issues such as binding
of the linkage or damage caused by the
actuator still rotating when the damper (or
other application) is already closed.
NOTE: For additional information about installing
MEP-7xxx actuators, see the MEP-7500/7800
Series Installation Guide on the KMC web
site (www.kmccontrols.com).
Maintenance
Under normal conditions, no routine maintenance is
required. In harsh environments, however, periodic
lubrication of the ball joints may be necessary.
Each component is designed for dependable, longterm reliability and performance. Careful installation
will also help ensure long-term reliability and performance.
Kit Contents:
• 1 crank arm
• 2 ball joints for 3/8"-diameter rod (rod not included)
• 2 mounting brackets
• Mounting screws
HLO-1020 1 Installation Guide
More Information
Important Notices
For additional information about installing
MEP-7xxx actuators,
see the MEP-7500/7800
Series Installation
Guide on the KMC web
site (www.kmccontrols.
com).
The KMC logo and KMC Controls are registered
trademarks of KMC Controls, Inc.
All rights reserved. No part of this publication may
be reproduced, transmied, transcribed, stored in a
retrieval system, or translated into any language in
any form by any means without the wrien permission of KMC Controls, Inc.
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
info@kmccontrols.com
HLO-1020 2 Installation Guide
© 2014 KMC Controls, Inc. 705-019-10C
Loading...