KMART CHIN UP STATION, 42994800 User manual

CHIN UP STATION

KC: 42994800

WARNING! READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS

PRODUCT. FAILURE OR INCORRECT OR EXCESSIVE TRAINING MAY
CAUSE INJURIES.

Safety Information

Please read this manual carefully before using and make sure that you read the

information supplied before commencing any exercise with this equipment.

1. Please consult a doctor before commencing any exercise with this equipment and if

you develop any uncommon symptoms during use you should seek further medical

advice.

2. The equipment must be placed on a hard, flat surface, cover the floor with carpet to

prevent damage to the ground.

3. Periodically checking all the parts for signs of wear or damage. If you find defective

parts, stop use immediately, make sure all problems are solved prior to continuing to

use.

4. While using, please wear suitable clothes and closed toe shoes for training to avoid

anything getting caught in the equipment.

5. Check all parts first before doing exercises. Tighten all the bolts and nuts on a regular

basis and never operate the equipment if it is not functioning properly.

6. You can mount and dismount on the equipment safely from the step by holding onto

the handle of the parallel bars.

7. Keep children away from the equipment unless they are supervised by an adult.

8. Create a realistic training plan before use, and use this product according to the

instructions of use in this instruction manual.

9. Product is in compliance with EN 20957-1 CLASS HC. Suitable for domestic home

use only.

Warning！please keep a safety
distance of 0.6m around the
training area during exercise.

0.6m

Technical Parameters

Overall size

150 x 106 x 212cm

Maximum user weight

100kg

Product total surface

1.59m

2

Product total weight

28.3kg

Hardware list

Bolt M10 x 75mm Bolt M10 x 70mm Bolt M10x65mm Washer M10 Nut M10

A x 4pc B x 18pc C x 2pc D x 56pc E x 28pc

Bolt M8 x 70mm Bolt M8 x 40mm Washer M8 Bolt M10 x 20mm Wrench 14/17mm plastic cover

F x 4pc G x 2pc H x 6pc I x 4pc J x 2pc K x 2pc

Parts list

Left base Right base Connection tube Low pole

L x 1pc M x 1pc N x 2pc O x 2pc

Strengthen pole Upper pole Connection tube Right overarm tube

P x 2pc Q x 2pc R x 1pc S x 1pc

Left overarm tube Hang up bar Back foam Armrest foam

T x 1pc U x 1pc V x 1pc W x 2pc

Assembly Instructions

Note: To assemble easily and successfully, please keep the bolts 70% of tightness while installing the parts, then fasten all

the bolts and nuts fully by wrench (Hardware J) after fully assembled.

Step 1. Connect the left & right base (Part L, M ) and connection tube (Part N) together, and secure them with bolts, washers and nuts

(Hardware B,D,E)