KlipXtreme KPM-955 Quick Installation Manual
Articulated tilt and swivel mount
for LED/LCD and plasma displays
Quick installation guide
KPM-955
Introduction:
Thank you for purchasing the KPM- 955 Tilt and swivel mount. This product is shipped with all
proper installation hardware and components. Upon opening the box, make sure that none of
these parts are missing and/or damaged before beginning installation.
1. Hardware kit
Label
A
B
C
D
E
F
M-A
M-B
M-C
M-D
M-E
Image
Item
Wall mount assembly
TV mount arm
Template
Tool-less threaded fastener
Nut wrench
Bubble level
M5x14mm screw
M6x14mm screw
M6x30mm screw
M8x30mm screw
M8x50mm screw
Quantity
1
2
1
2
1
1
4
4
4
4
4
Label
M-F
M-G
M-H
W-A
W-B
W-C
Image
Item
Rectangular washer
Short round spacer
Long round spacer
Lag bolt
Concrete anchor
Metal flat washer
Quantity
4
8
8
6
6
4
IMPORTANT:
At least two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the display.
CAUTION: Verify the adequate thread engagement of the screw/spacer combination on
your TV. Too short will not hold the TV and too long will damage the TV.
Too short Correct Too long
Maximum flat or curved panel weight:
75kg
Max load
165lb
The wall structure must be capable of supporting at least five times the weight of the flat
panel. Otherwise, the wall structure must be reinforced.
2. WARNING!
•
Prior to installing this product, you must read all instructions thoroughly. Keep these
installation instructions in an easily accessible location for future reference.
•
Safety measures must be practiced at all times during the assembly of this product. Use
proper safety equipment and tools for the assembly procedure to prevent personal injury.
•
Klip Xtreme does not warrant against damage caused by the use of any Klip Xtreme mounts
for purposes other than those for which it was designed or damage caused by unauthorized
attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any manner
relating to any such use, attachments or modifications.
3. Installation of the mount arms to the rear panel of the screen
Place your flat panel screen-side down on a soft, even surface, and identify the threaded
1.
mounting points that are located on the back of the flat panel.
Determine the correct screw size by carefully inserting a straw or toothpick, and mark the
2.
depth of the mounting point. Please note that not all the hardware included will be used.
Attach the bracket arms to the flat panel by aligning the holes with the threaded
3.
inserts on the back of the display.
Standard flat panel mount installation
If your display has an irregular back or recessed mounting points, spacers must be placed
4.
between the mounting arm and the back of the screen to compensate the difference in
depth.
Curved screens and flat panels with an
irregular back or recessed mounting points
Use the recommended screws and rectangular washers to secure both arms to the display.
5.
Be careful not to over-tighten the screws.
4. Wall mount installation
Use the provided template to mark the mounting positions on the wall.
1.
For gypsum or wooden walls, first locate studs. You may use a stud finder to determine the
2.
center of each stud.
Next, mark the first two found stud positions on the wall.
3.
Make sure the mounting slots are aligned vertically and centered on the stud.
4.
Loading...