Klipsch RF-5 Brochure

Dual 8'' Two-Way Floorstanding Loudspeaker
RF-5
Designed to the same standards as our flagship RF-7, the RF-5’s sonic clarity and impact, from top to bottom, place it in the very top echelon of high-performance loudspeakers. And it is so amazingly efficient that it demands only about one-eighth the amplifier power of conventional speakers. Whether standing alone in a high-end stereo music system or anchoring a powerhouse home theater, the RF-5 brings the experience home with maximum intensity.
The RF-5’s tweeter is a 1-inch titanium dome compression driver with an uncommonly large
9.6-ounce magnet. It is loaded by an 8-inch
®
square 90° x 60° Tractrix the driver’s efficiency and controls its radiation pattern to minimize detail-blurring reflections from walls, floor, and ceiling. The dual 8-inch woofers have stiff cones, rigid, low-resonance cast-polymer frames, and massive 28-ounce magnets, enabling them to generate staggering levels of bass without strain or distortion. All drivers are magnetically shielded to prevent interference with direct-view television sets.
Amplifier connections are via two pairs of binding posts, which are linked with jumpers for normal wiring. Removing the jumpers allows the speaker to be bi-wired. The speaker diffraction, and its feet can be fitted with rubber pads or spikes. The rear-ported cabinet is available finished in Medium Cherry, Blonde Maple, or Black Ash wood veneer.
’s “
, lightweight Cerametallic™
floating” grille minimizes
Horn, which raises
Extremely high sensitivity, power handling, and output capability
Tractrix Horn titanium dome compression driver tweeter for clean,
detailed highs
Cerametallic cone woofers with cast-polymer frames
Bi-wire compatible inputs
Magnetically shielded to prevent video interference
Real wood veneer finishes
SPECIFICATIONS
BANDWIDTH 34Hz-20kHz ± 3dB
SENSITIVITY 99dB @ 2.83 volts/1 meter
NOMINAL IMPEDANCE 8 ohms compatible
CROSSOVER FREQUENCY 2500Hz
POWER HANDLING 150 watts (600 watts peak)
ENCLOSURE TYPE Bass-reflex via rear-firing port DRIVE COMPONENTS Two way system using one 1'' (2.5cm)
magnetically shielded, titanium diaphragm
ession dr
pr
com square 90˚x 60˚ Tractrix horn and two 8'' (20.3cm) magnetically shielded, Cerametallic
oof
cone w
WEIGHT 62 lbs. (28.2kg)
HEIGHT 42.3" (107.4cm) w/feet, 41.4'' w/o feet
WIDTH 9" (22.9cm)
DEPTH 16.4'' (41.7cm) w/grille, 14.5'' w/o grille FINISH Black Ash or Medium Cherry wood veneer
iver with an 8'' (20.3cm)
s
er
www.klipsch.com
1-800-KLIPSCH
All specifications are subject to change without notice. ©2004
Loading...