KLIK LEDpod 50 Installation Instructions Manual

PAGE 1 OF 2

32864-C.1

www.klikusa.com - [e-mail]

1.34”

KLIK LEDpod™ 50 Installation Instructions

Ø 0.96”

1.75”

OD

2.38”

Make sure drilled holes are

1

deburred and excess swarf
is removed from railing.

Ø 1.02”

Use a 25mm annular cutter

to bore hole.

(Use 1” in aluminum.)

Ø 25 ± 0.2mm

Thru.

wire

Aprx 2”

Pull a loop of wire through hole.

3 4 5

Rotate retaining clips in as shown. Avoid
tangling or severing through wire.

90°

POSITIVE [ + ]: Red

NEGATIVE [ - ]: Black

Feed through appropriate

2

wires

(0.75-1.5mm²).

Apply pressure as shown to deform clip into place in a
circular motion. Avoid damaging the surface of tube
and tangling or severing through wire.

Fit clip into place until the clamping

6 7

ends are equally centered over the
hole. Use the tool to center the clasp
until equal pressure can be felt and
inspect by eye.

Light
direction

Push LEDPOD in until it snaps into place

9

and the outer surface is flush with the outer
surface of the tube.

Prod the rim of the clear silicone IP Seal to
provide a tighter fit.

The notch indicates
the direction of t he light,
Asymmetrical LEDPods

Install Scotchlok connectors to the (0.75-1.5sq) red
and black wires. Connect the corresponding color
wires of the driver to the Scotchloks and assure the
clip is secured.

CAREFULLY feed the Scotchloks to the left of

8

the clip and the driver to the right with the
driver connector hanging out. Ensure wires
are clear from where the LEDPOD is to fit.

Proceed to connect the LEDPOD.

LEDPOD Removal Steps

Insert removal tool into the

1 2 3

2mm holes in the LEDPOD.

With firm pressure, rotate
the LEDPod 90°.

Carefully peel back
the IP silicone seal
one side at a time.

Be sure to re-attach
the silicone seal ready
for reinsertion.

Carefully remove the LEDPOD
from the clip, ensuring not to
damage or disconnect wires in
the process.

www.klikusa.com - [e-mail]

PAGE 2 OF 2

32864-C.1

KLIK LEDpod™ Soft Start Relay Installation Instructions

Feed power wires
through tubing

4

1

Aprx 2”

Carefully pull out a
loop of wire at the
first LEDPOD location.

Match colors of wires as shown in the images below.

Insert wires into connectors as far as possible and push down blue tabs to splice the wires.

IMPORTANT : Connect to 24 - 42V DC supply input to the Blue and Red Soft starter

DO NOT connect power to any other wires.

24 - 42V DC IN Black
Negative [-]

2

To LEDPods

OUTPUT

Cut wires at the center
of the loop.

24 - 42V DC IN Red
Positive [+]

3

24VDC Supply

INPUT

Soft starter complete
with pre-fitted connectors

5

Blue IN
Negative [-]

Black OUT
Negative [-]

LEDPOD OUT
Black Negative [-]

To LEDPODs

OUTPUT

Red IN
Positive [+]

Red OUT
Positive [+]

LEDPOD OUT
Red Positive [+]

6

To 24V DC Supply

INPUT

Carefully feed one
connector at a time
through the
LEDPOD holes.

Move components down to make room for retaining clip insertion.

Refer to page 1 for LEDPOD installation instructions.