Page 1
FIG. 1
APPLICATIONS
that become airborne during activities such as grinding, sanding, or processing wood, minerals, flour, iron, coal, and certain other substances.
WARNINGS
To ensure safe operations, follow these instructions. Failure to observe these warnings and instructions may result in sickness or death.
use against vapors, paint spray, oil-based aerosols, asbestos and sandblasting.
use against any contaminant whose concentration is unknown, or immediately dangerous to life
use against vapors, paint spray, oil-based aerosols, asbestos and sandblasting.
use against vapors, paint spray, oil-based aerosols, asbestos and sandblasting.
use against concentrations of dust and mists which exceed the maximum use concentration, or 10 times contaminant’s
use against any contaminant whose concentration is unknown, or immediately dangerous to life
use against any contaminant whose concentration is unknown, or immediately dangerous to life
use against concentrations of dust and mists which exceed the maximum use concentration, or 10 times contaminant’s
use against concentrations of dust and mists which exceed the maximum use concentration, or 10 times contaminant’s
alter or modify the respirator.
suitable for persons with beard or other facial hair which may reduce the efficacy of respirator.
alter or modify the respirator.
alter or modify the respirator.
suitable for persons with beard or other facial hair which may reduce the efficacy of respirator.
suitable for persons with beard or other facial hair which may reduce the efficacy of respirator.
NOTE: Before occupational use of this respirator, a written respiratory protection program must be implemented meeting all the
evaluation, training, and t testing.
Hold the respirator in one hand with the nose area at your fingertips, allowing the headbands to hang below your hand.
Press the respirator against your face with the nose foam on the bridge of your nose.
Place the top headband high on the back of your head. Move the bottom band over your head and position it below your ears.
Test the fit. Cup both hands over the respirator and inhale vigorously. If no negative pressure is felt inside the respirator,
Test the fit. Cup both hands over the respirator and inhale vigorously. If no negative pressure is felt inside the respirator,
Test the fit. Cup both hands over the respirator and inhale vigorously. If no negative pressure is felt inside the respirator,
FIG. 2
ENGLISH
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
FIG. 3
FIG. 4
(40°C)
(-20°C)
THIS RESPIRATOR IS ONLY APPROVED IN THE FOLLOWING CONFIGURATIONS:
TC- PROTECTION
84A-7720 N95 X ABCJMNOPS
1. PROTECTION:
N95 - Particulate Filter (95% filter efficiency level) effective against particulate aerosols free of oil; time use restrictions may apply.
2. CAUTIONS AND LIMITATIONS:
A - Not for use in atmospheres containing less than 19.5 percent oxygen.
B - Not for use in atmospheres immediately dangerous to life or health.
C - Do not exceed maximum use concentrations established by regulatory standards.
J - Failure to properly use and maintain this product could result in injury or death.
M - All approved respirators shall be selected, fitted, used, and maintained in accordance with MSHA, OSHA, and other applicable regulations.
N - Never substitute, modify, add, or omit parts. Use only exact replacement parts in the configuration as specified by the manufacturer.
O - Refer to User Instructions, and/or maintenance manuals for information on use and maintenance of theserespirators.
P - NIOSH does not evaluate respirators for use as surgical masks.
S - Special or critical User Instructions and/or specific use limitations apply. Refer to User Instructions before donning.
RESPIRATOR COMPONENTS
1
RESPIRATOR
60440
CAUTIONS AND LIMITATIONS
2
Find Quality Products Online at: [email protected]
www.GlobalTestSupply.com
Loading...