Page 1
CookingCooking
RH5 - 900mm Slide Away Rangehood
c o l l e c t i o nc o l l e c t i o n
Instructions for Use
and
Warranty Details
RH4 - 600mm Slide Away Rangehood
Page 2
ongratulations on the purchase of your new
C
designed and manufactured to give you years
For best results, carefully read the instructions on
how to install your new appliance. Correct installation
will avoid delays and unnecessary service calls.
Once installation is complete, read this booklet
carefully and get to know the controls and the
We reserve the right to alter the specifications
appliance. This instruction manual cannot be
appliance. This appliance has been
of reliable performance.
features of your new appliance.
with no influence on the operation of the
reason for a claim.
Page 3
1
2
1.1
2.1
6
4
3
5
1.2
6
4
5
G
3
F
G
C
CLOSED
OPEN
A
A
B
1.3
D
2.2
2.3
3
H
1
2
3
K
4
5
Page 4
D
6
7
M
N
1
2
3
4
8
10
9
P
O
Q
11.1
O
P
R
11.2
Page 5
Introduction to the Hood - Fig. 1.1
1. Light Switch
2. Motor Speed Switch
3. Illumination of the cooking surface
4. Grease Filters/grease filter support grate
5. Light Cover Supports
6. Pull-Out Drawer
Model with Grease Filter Support Grate
Opening the Grease Filter Support Grates - Fig. 2.1
a. Remove the pull-out drawer completely.
b. Push the A knobs inwards toward each other (in the
“Open” direction as indicated on the plastic knob itself).
c. To remove the grates completely, use the B spring
fasteners, which act as pins to hold the grate in place
(Fig. 3).
Model with Self-supporting Metal Filters
Removing the Grease Filters - Fig. 2.2
a. Remove the pull-out drawer completely.
b. Press the side handles C (some models are supplied
with handles Z - Fig. 2.3) towards the opposite side
and remove the filters.
Putting the Filters Back in Place
a. Remove the pull-out drawer completely and mount the
grease filter so that it covers the drawer.
b. Close the drawer and install the remaining grease filter.
Opening the Light Cover Support
a. Remove the pull-out drawer completely.
b. According to model in possession:
Lamp D with hook locks type A - Fig.2.2
Move the bracket hook locks towards each other (in
direction “Open” as printed on the plastic part of the
lock). Lamp F with hook locks type G - Fig. 1.2
Move the hook locks as indicated by the arrows and
completely remove the lamp from the housing (Fig.
1.3).
Systems Available
Venting Outdoors
The air is vented outdoors through a duct which must be
connected to the exhaust opening K (Fig. 5) by means of
the flange H. The diameter of the exhaust duct must be
exactly the same as that of the flange.
Air Recirculation
— The air is cleaned by means of charcoal filters and then
circulated back into the room.
— The use of a charcoal filter is necessary when the hood
cannot vented outdoors either because ducting is not
available or cannot be installed.
— The filtered air is returned from atop the cabinet through
a duct that passes through the cabinet itself.The
diameter of the duct must be the same as that of flange
GB
H (Fig. 5).
The deflector J can be fixed to the outlet hole using the
two screws provided
(Fig. 4).
T o fit or replace a carbon filter:
a. Request a charcoal filter from the retailer, specifying
the model and type of hood.
Caution! Some charcoal filters come covered with a
plastic film to protect their filtering properties. If this is the
case, remove the film before installing the filter.
b. Remove the pull-out drawer completely.
c. Remove the grease filters or the grates.
d. Place the activated carbon filter in position:
1) Version with one motor: insert the filter in its housing
over the plastic grill and rotate it until it locks in
position (Fig. 6).
2) Version with two motors: to assemble the filter,
insert it in its seating and fix it in position using the
clips L (Fig. 7)
e. Remove the grease filters or grills
To remove the carbon filter, follow the procedure
described in item 1) or 2), depending on the version) in
the reverse order.
Installation
When installed, the distance between the hood and burners
must be not less than 43 cm for electric burners or 65 cm
for gas or mixed-fuel burners.
Caution
This appliance is designed to be operated by adults.
Children should not be allowed to tamper with the controls
or play with the appliance.
Do not use the cooker hood where the grill is not correctly
fixed! The suctioned air must not be conveyed in the same
channel used for fumes discharged by appliances powered
by other than electricity. The environment must always
be adequately aerated when the cooker hood and other
appliances powered by other than electricity are used at
the same time. Flambé cooking with a cooker hood is
prohibited. The use of a free flame is damaging to the filters
and may cause fire accidents, therefore free flame cooking
must be avoided. Frying of foods must be kept under close
control in order to avoid overheated oil catching fire. Carry
out fumes discharging in accordance with the regulations
in force by local laws for safety and technical restrictions.
The manufacturers refuse to accept any responsibility for
damage to the hood or its catching on fire because of failure
to observe the above instructions.
Electrical connection
The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where provided, to the an easily accessible
7
Page 6
outlet in conformity with local standards in force.
Where an electrical plug is not provided (for direct
connection to electrical network) place a standards approved
bipolar switch with an aperture distance of not less than
3mm (accessible) from the contacts.
Mounting the Hood
The diameter of the ventilation duct must be the same as
the that of the flange mounted on the ventilation hole on the
hood.
To mount the hood proceed as follows:
— Position the drilling template inside the left cupboard
on the right hand side with the arrow point towards
the back on the cupboard (Fig. 8)
— Drill the holes marked on the template (Fig. 8)
— Repeat the procedure for the right hand cupboard
— If the sides of the cupboards are 18 mm thick, insert
4 spacers M on the sides of the hood (Fig. 9)
— Fix the hood to the cupboard using four screws N
(Fig. 9).
Adjusting the Pull-Out Drawer
The hood can be installed beneath cabinets with varying
depths. Adjustments for opening and closing the drawer
can be made based on your specific needs.
To adjust the drawer, remove the ventilation grates by
loosening the O screws and adjusting the P brackets. Then
retighten the O screws (Fig. 10).
Using the hood
The hood is provided with several speeds.
For the best performance, we recommend using the low
speeds in normal conditions and the high speeds when
strong odour and vapour concentrations are present.
We recommend starting the hood a few minutes before
cooking and keeping it running for at least 15 minutes until
all the odours have been eliminated.
Maintenance
Caution! Before performing any maintenance,
disconnect the hood from the electrical supply.
Grease Filter
The grease filter serves to trap grease particles by
suspending them.
1. Synthetic Filter (thickness: 10-15 mm): wash the
filter in warm water and a biodegradable detergent
once a month. Let dry without wringing. Replace after
the filter has been washed 5 or 6 times.
2. Thin Synthetic Filter (approximately 1 mm thick):
replace when the coloring from the top is visible on the
bottom part.
3. Thin Synthetic Filter (approximately 1 mm thick -
without saturation indicator) replace every two months.
4. Metal Filter: unlimited life; wash every month in
GB
warm soapy water, or, if possible, in the dishwasher
(60°C). Let dry before reinstalling it.
Removing the Grease Filters (for models wtih grease
filter support grates)
To remove the dirty grease filter, proceed as follows:
a. Remove the pull-out drawer completely and open the
ventilation grates that support the grease filters.
b. Remove the Q fasteners for the grease filter and
remove it (Fig. 11.1). If special metal filters have been
installed, press on the plastic springs R to unhook them
(Fig. 11.2).
c. When washing or replacing the grease filter, wash the
grate as well with warm soapy water.
d. Remount the new filter or the old one after it has dried
thoroughly.
Charcoal Filter
The charcoal filter serves to eliminate odours that form
during the cooking process. Under normal use conditions,
the filter should be replaced every 4 months. It can be
ordered from the retailer. The charcoal filter must never be
washed.
To remove the charcoal filter, proceed as follows:
a. Remove the pull-out drawer.
b. Remove the grease filters and open the light cover
support (or the greas filter support grate).
c. Reverse the procedure described in item 1) or 2),
depending on the version, of the “Air recirculation”
paragraph.
Replacing the Lamp
a. Remove the pull-out drawer.
b. Open the light cover support or the back grease filter
support grate.
c. Always replace burnt-out lamps, according to what is
provided for your appliance, with olive-shaped max.
40 Watt (E 14) bulbs, or neon-lamp 14 Watt max., or
PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt
(two PL lamp appliance).
d. Close the light cover support or the back grease filter
support grate.
e. Before calling for customer service because the
lighting system does not work, make sure that the
lamps are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth moistened with
denatured alcohol or neutral liquid detergents. Never use
products containing abrasives.
Attention
Failure to observe the instructions for cleaning the appliance
and changing and cleaning the filters may cause fires.
Therefore, we recommend observing these instructions.
8
Page 7
WARRANTY AND SERVICE
DOMESTIC WARRANTY - FULL FIVE YEAR WARRANTY
In addition to all statutory rights which you, the Consumer, have under the relevant laws in respect
of this appliance, during the first five years of ownership as the original purchaser of this
Kleenmaid appliance, we guarantee that any fault caused by faulty material or workmanship
becoming apparent will be rectified free of charge for parts and labour, provided that all service is
performed during normal working hours by Kleenmaid or their designated Agents. Where the
appliance is installed outside the normal servicing area of the above, the Purchaser must pay for
the cost of transporting the appliance to and from the Agent or the Agent’s travelling cost to and
from the Purchaser’s home.
COMMERCIAL WARRANTY - ONE YEAR WARRANTY
When this appliance is installed in a commercial application, you, the Consumer, have under the
relevant laws in respect of this appliance, during your first one year of ownership as the original
purchaser of this Kleenmaid appliance, we guarantee that any fault caused by faulty material or
workmanship becoming apparent, will be rectified free of charge for parts and labour, provided that
all service is performed during normal working hours by Kleenmaid or their designated Agents.
Where the appliance is installed outside the normal servicing area of the above, the Purchaser
must pay for the cost of transporting the appliance to and from the Agent or the Agent’s travelling
cost to and from the Purchaser’s home.
WHAT THESE WARRANTIES DO NOT COVER
We are not responsible for any damage or malfunction unless caused by a defect in material or
workmanship. This includes but is not limited to abuse, misuse, improper installation and
transportation damage. We are not responsible for any consequential damages from any
malfunction.
The Consumer must make the appliance available for servicing and shall bear any costs incurred
for any de-installation and/or re-installation required to make the appliance available for servicing.
Kleenmaid is not liable for any consequential damage incurred during de-installation or reinstallation.
WARRANTY DOES NOT COVER REPLACEMENT OF LIGHT
GLOBES OR GLASS BREAKAGE DUE TO IMPACT
In case of fractured glass do not use your appliance.
WARRANTY REGISTRATION
Please complete warranty details below and retain together with your proof of purchase document
These documents will need to be viewed by our Service Representative should you request in warranty
service.
SERVICE ASSISTANCE
To assist you when phoning our After Sales Service number to arrange a service call please complete
the following details and have them ready when you call.
Model Number_____________________________Date of purchase____________________________
Kleenmaid Store purchased from_________________________Date of installation ________________
KLEENMAID AFTER SALES SERVICE
1300 652 100
Page 8
Other products available in the Kleenmaid
Range of appliances
Washers
Dryers
Dishwashers
Ovens
Cooktops
Outdoor Cooking Centres
Built In Espresso Coffee Machines
Rangehoods
Freestanding Ranges
Sinks
Waste Disposals
Taps
Cookware
Refrigerators
Freezers
Wine Cellars
Vacuum Cleaners
For sales information on the full range of quality appliances
Phone 13 13 08
Loading...