Kleenmaid RH1A User Manual

CookingCooking

c o l l e c t i o nc o l l e c t i o n

Instructions for Use

and

Warranty Details

RH1A - 600mm Slide Away Rangehood

RH3A - 900mm Slide Away Rangehood

ongratulations on the purchase of your new

C

designed and manufactured to give you years

For best results, carefully read the instructions on

how to install your new appliance. Correct installation

will avoid delays and unnecessary service calls.

Once installation is complete, read this booklet

carefully and get to know the controls and the

We reserve the right to alter the specifications

appliance. This instruction manual cannot be

appliance. This appliance has been

of reliable performance.

features of your new appliance.

with no influence on the operation of the

reason for a claim.

Figure A

1. Motor Speed Switch

2. Light Switch

3. Sliding Hood

4. Grease Filter

5. Cooking Surface Lighting

6. Removable Decor Trim

Pipe size = 100mm

Not supplied

USING THE HOOD

The hood can be used in the following ways:

1. External exhausting (with external
venting), and

2. Recycling (with carbon filter)

EXTERNAL
EXHAUSTING MODEL

Figure B

This model is used when there is no
possibility of installing an external vent.
The carbon filter is NOT fitted to the unit
when packed.
If external venting is to be used, the carbon
filter can be purchased from your Kleenmaid
St George Store.

The replaceable carbon filter filters out
odours when the unit is used without
external venting. It must be replaced every
six months.

To access the filter and other internal
components, do the following:

1. Slide out hood – No. 3 (Figure A)

2. Turn slotted screws A (Diagram 2) 90°

3. Remove grease filter – No. 4 (Figure A)

4. Remove carbon filter by rotating

anticlockwise as per (Diagram 3)

FITTING THE HOOD

RECYCLING CARBON
FILTER MODEL

The air is exhausted out by means of pipes
connected to the coupling ring B (diag. 1).

Figure C

The air is filtered through a carbon filter and
then sent back into the room.

The hood should be mounted over the centre
of the cooking area.
The space between the cooker and the
underside of the hood should be at least

650mm for electric and 650mm for gas

cookers.

Important: Please check with local
electrical and gas regulations.

The unit is designed to be fitted in a cupboard
as per Diagram 4. Use the template supplied
and drill 5mm holes where indicated. Also
drill out the 110-115mm dia. hole to facilitate
venting that will lead either outside (externally
vented) or through the top of the cupboard
when utilising the carbon filter in the recycling
mode.
Ensure the flange is fitted as per Diagram 1.
Use the 4 screws provided to secure the
hood to the cupboard. Adjust the 90° angle
frame L (Diagram 4) using the screws E
(Diagram 2) and secure to the rear wall.

WARRANTY AND SERVICE

DOMESTIC WARRANTY - FULL FIVE YEAR WARRANTY

In addition to all statutory rights which you, the Consumer, have under the relevant laws in respect
of this appliance, during the first five years of ownership as the original purchaser of this
Kleenmaid appliance, we guarantee that any fault caused by faulty material or workmanship
becoming apparent will be rectified free of charge for parts and labour, provided that all service is
performed during normal working hours by Kleenmaid or their designated Agents. Where the
appliance is installed outside the normal servicing area of the above, the Purchaser must pay for
the cost of transporting the appliance to and from the Agent or the Agent’s travelling cost to and
from the Purchaser’s home.

COMMERCIAL WARRANTY - ONE YEAR WARRANTY

When this appliance is installed in a commercial application, you, the Consumer, have under the
relevant laws in respect of this appliance, during your first one year of ownership as the original
purchaser of this Kleenmaid appliance, we guarantee that any fault caused by faulty material or
workmanship becoming apparent, will be rectified free of charge for parts and labour, provided that
all service is performed during normal working hours by Kleenmaid or their designated Agents.
Where the appliance is installed outside the normal servicing area of the above, the Purchaser
must pay for the cost of transporting the appliance to and from the Agent or the Agent’s travelling
cost to and from the Purchaser’s home.

WHAT THESE WARRANTIES DO NOT COVER

We are not responsible for any damage or malfunction unless caused by a defect in material or
workmanship. This includes but is not limited to abuse, misuse, improper installation and
transportation damage. We are not responsible for any consequential damages from any
malfunction.
The Consumer must make the appliance available for servicing and shall bear any costs incurred
for any de-installation and/or re-installation required to make the appliance available for servicing.
Kleenmaid is not liable for any consequential damage incurred during de-installation or re­installation.

WARRANTY DOES NOT COVER REPLACEMENT OF LIGHT
GLOBES OR GLASS BREAKAGE DUE TO IMPACT

In case of fractured glass do not use your appliance.

WARRANTY REGISTRATION

Please complete warranty details below and retain together with your proof of purchase document

These documents will need to be viewed by our Service Representative should you request in warranty
service.

SERVICE ASSISTANCE

To assist you when phoning our After Sales Service number to arrange a service call please complete
the following details and have them ready when you call.

Model Number_____________________________Date of purchase____________________________

Kleenmaid Store purchased from_________________________Date of installation ________________

KLEENMAID AFTER SALES SERVICE

1300 652 100

Other products available in the Kleenmaid

Range of appliances

Washers

Dryers

Dishwashers

Ovens

Cooktops

Outdoor Cooking Centres

Built In Espresso Coffee Machines

Rangehoods

Freestanding Ranges

Sinks

Waste Disposals

Taps

Cookware

Refrigerators

Freezers

Wine Cellars

Vacuum Cleaners

For sales information on the full range of quality appliances

Phone 13 13 08