Kleenmaid RH10 User Manual

RANGEHOOD

Rangehoods RH10 - Canopy 1000mm
Rangehoods RH11 - Canopy 900mm

c o l l e c t i o n

Instructions for Use

and Warranty Details

ongratulations on the purchase of
your new appliance. This
appliance has been designed and

I

C

results, carefully read the instructions on how to
install your new appliance. Correct installation
will avoid delays and unnecessary service calls.

Once installation is complete, read this booklet
carefully and get to know the controls and the
features of your new appliance.

We reserve the right to alter the specifications
with no influence on the operation of the

appliance. This instruction manual cannot be

reason for a claim.

I

manufactured to give you years of
reliable performance. For best

2

Mounting the hood - Wall model

3

Mounting the hood - Ceiling model

4

Control panel - Fig. 1 -

a. "ON" indicator light
b. Light ON-OFF button
c. Motor OFF button
d. e. f. Motor speed buttons
speed 1 (d.), speed 2 (e.), speed 3 (f.)

Use of the hood

It is advisable to switch on the extractor
hood a few minutes before starting cooking
and then to leave it running for approximately
5 minutes afterwards to ensure that all odours
are extracted.

Maintenance

Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.

Metal grease filter

The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at least
once a month.

Let the filter dry without damaging it before
putting it back into place.

To remove the metal grease filter - Fig. 2:

1. Disconnect the hood from the electricity.

2. a - push toward the centre
b - pull the filters downwards.

Carry out the above steps in reverse order to
put the filters back after having washed
them.

GB

To fit the carbon filter - Fig. 3:

1. Disconnect the hood from the electricity.

2. Remove the metal filters.

3. Fit the carbon filter and fix it to the body of

the hood with two supplied screws

4. Put the metal filter back into place.
To replace the carbon filter - Fig. 3:

1. Disconnect the hood from the electricity.

2. Remove the metal filters.

3. Remove the old carbon filter and replace

it.

4. Put the metal filter back into place.

Cleaning

To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.

Attention

Failure to observe the instructions for
cleaning the appliance and changing and
cleaning the filters may cause fires.
Therefore, we recommend observing these
instructions.

Replacing the lamp - Fig. 4

1. Disconnect the hood from the electricity.

2. Unscrew the lamp cover.

3. Replace the damaged lamp with a new

halogen lamp of 20Watt max.

4. Screw the lamp cover on its proper place.
Before calling for repair service because the
hood fails to light up, make sure the lamps
are well inserted.

Carbon filter

(“recirculation mode only”, see next pages)
The carbon filter cannot be washed nor
regenerated.
The carbon filter should be replaced every 6
months under normal use.

9

Warning!

— The hood cannot be connected to flues of

other appliances that run on energy
sources other than electricity.

— When the hood is used at the same time

of other appliances that run on energy
sources other than electricity, provision
must be made for an adequate supply of
air.

—No food must be cooked flambé

underneath the hood.
The use of an unprotected flame is
dangerous for the filters and could cause
fires.
Therefore, never use an open flame under
the hood. When frying foods, never leave
the pan alone because the cooking oil
could flare up.

— Please, keep to the provisions of official

directives regarding the question of fume
discharge.

— The manufacturers refuse to accept any

responsibility for damage to the hood or
its catching on fire because of failure to
observe the above instructions.

Installation

These minimum distances between hobs
and grease filter must be observed:
Minimum 600 mm - electric hobs
Minimum 700 mm - gas or mixed hobs

Electric connection

Before completing any connection, make
sure the house voltage corresponds with the
voltage indicated on the label affixed inside
the hood
It is advisable to call a qualified technician to
make the electrical connection.

Appliance fitted with plug.

Connect it to a socket which conforms with
current regulations.
If you intend to connect it directly to the
electric mains, remove the plug and fit an
approved bipolar switch with a minimum
contact opening of no less than 3mm.
If the plug is not accessible once it has been
inserted in the socket, it will however be

GB

necessary to fit an approved bipolar switch
with a minimum contact opening of no less
than 3mm.

Appliance without plug

Fit an approved plug or an approved bipolar
switch with a minimum contact opening of
not less than 3mm.
The manufacturers are not liable for any
problems caused by the user’s failure to
observer the above instructions.

Systems available

Two systems are available:

Exhaust mode

Vapours are extracted outside through an
exhausting pipe that is affixed to the
connection ring above the hood.
Diameter of the exhausting pipe must be
equal to that of the connection ring.

Attention!
If the hood is supplied with carbon filter,
then it must be removed.

Recirculation mode

The air is filtered through a carbon filter and
recirculated into the room through the grid
on the higher part of the chimney.

Attention!
If the hood is not supplied with carbon
filter, then it must be ordered and
mounted.

10

W ARRANTY AND SERVICE

KLEENMAID AFTER SALES SERVICE

1300 652 100

DOMESTIC WARRANTY - FULL FIVE YEAR WARRANTY

In addition to all statutory rights which you, the Consumer, have under the relevant laws in respect of this
appliance, during the first five years of ownership as the original purchaser of this Kleenmaid appliance, we
guarantee that any fault caused by faulty material or workmanship becoming apparent will be rectified free of
charge for parts and labour, provided that all service is performed during normal working hours by Kleenmaid
or their designated Agents. Where the appliance is installed outside the normal servicing area of the above,
the Purchaser must pay for the cost of transporting the appliance to and from the Agent or the Agent’s
travelling cost to and from the Purchaser’s home.

COMMERCIAL WARRANTY - ONE YEAR WARRANTY

When this appliance is installed in a commercial application, you, the Consumer, have under the relevant
laws in respect of this appliance, during your first one year of ownership as the original purchaser of this
Kleenmaid appliance, we guarantee that any fault caused by faulty material or workmanship becoming
apparent, will be rectified free of charge for parts and labour, provided that all service is performed during
normal working hours by Kleenmaid or their designated Agents. Where the appliance is installed outside the
normal servicing area of the above, the Purchaser must pay for the cost of transporting the appliance to and
from the Agent or the Agent’s travelling cost to and from the Purchaser’s home.

WHAT THESE W ARRANTIES DO NOT COVER

We are not responsible for any damage or malfunction unless caused by a defect in material or workmanship.
This includes but is not limited to abuse, misuse, improper installation and transportation damage. We are
not responsible for any consequential damages from any malfunction.

WARRANTY DOES NOT COVER REPLACEMENT OF LIGHT
GLOBES OR GLASS BREAKAGE DUE TO IMPACT

In case of fractured glass do not use your appliance.

WARRANTY REGISTRATION

Please complete the enclosed warranty card and retain it together with your proof of purchase document.

These documents will need to be viewed by our Service Representative should you request

in warranty service.

SERVICE ASSISTANCE

To assist you when phoning our After Sales Service number to arrange a service call please
complete the following details and have them ready when you call.

Model Number ________________________________________Date of purchase_____________________________

Kleenmaid Store purchased from__________________________Date of installation ____________________________

Other products in Kleenmaid’s

range of world’s best appliances:

Washers

Dryers

Dishwashers

Ovens

Cooktops

Rangehoods

Sinks

Waste Disposals

Taps

Cookware

Refrigerators

Freezers

Vacuum Cleaners

For sales information on the full range of quality
kitchen and laundry appliances, phone 13 13 08

PO Box 5560 MAROOCHYDORE BC QLD 4558

Kleenmaid Head Office: