Page 1
cooking collection
Instructions for use and warranty details
Model No.: KC
Page 2
Dear Customer,
Thank you and congratulations for choosing
Kleenmaid.
Your new appliance has been designed
and meticulously tested to ensure that it
meets all your culinary requirements, and
has been carefully manufactured using top
quality materials to give you years of reliable
performance.
For best results, carefully read the instructions
on how your new appliance is to be installed.
Correct installation will avoid delays and
unnecessary service call costs.
Once installation is complete, please read this
instruction manual carefully and get to know
the controls and the features of your new
Kleenmaid appliance. These simple instructions
will enable you to achieve excellent results from
the very first time you use it.
Again, congratulations and thank you for
choosing The Best You Can Own.
KLEENMAID
Page 3
Page 4
Page 5
can be installed on walls between 203mm and 229mm
tall.
.
610mm.
1. Read this manual carefully and completely.
2. The range hoods conform to related appliances standards. Please check
your local building codes for any
additional requirements.
3. The appliance has been manufactured as class I, there?fore ground connection is necessary. The range hood
must be installed so that that the plug is easily accessible.
Before You Start...
Remove the packaging with the product in place. Cut off the packing ribbons and carefully cut open the packaging
(do not cut too deeply), remove the packaging.
Check that the product is free from transport damage.
shall be reported immediately to the carrier or seller.
Any damage
Damage, faults and missing parts must be reported immediately
to the seller.
Unpacking Unpacking
Page 6
2. Install a roof or wall cap. Connect a 150mm round metal duct to the cap
and work backwards toward the hood. Ensure joints are completely sealed
with duct tape.
1. Plan where the ductwork will run between the hood and the outside.
The hoods exhaust vertically but can be ducted to the rear behind the
chimney duct through an outside wall or vertically up through the ceiling
to the roof. A short straight duct run will produce the most air flow.
Length and elbows will reduce the efficiency of the blower.
1. Before mounting the hood, plug in and test all functions for proper operation.
2. Removed the filters from the bottom of the hood to prevent damage during
the installation.
3. With assistance, hold the hood temporarily in position ensuring the bottom is
above the minimum clearance for the cooking surface. Mark on the wall the
holes for the two mounting screws.
4. Drill the holes (A) at the distances indicated. Use the appropriate screws and
screw anchors for your wall type (e.g. reinforced concrete, drywall, etc.).
If necessary, prepare back wall with cross framing for secure installation.
5. Mount the hood on the wall screws. Align it in a horizontal position relative to
cabinets. When the hood has been adjusted, secure unit by tightening screws (A).
6. Connect a 150mm aluminum duct tube (not included) to the exhaust piece using
duct tape on all seals. (C)
1. Carefully loosen but do not separate the telescopic chimney duct pieces.
2. Arrange the electrical power supply within the dimensions of the decorative
chimney duct.
3. Adjust the width of the support bracket to match the upper duct.
Fix it to the
ceiling using the screws (B) so that it is centered in line with your hood and
at a distance from the ceiling indicated.
Fixing the Decorative Chimney
Flue
Installing the Ductwork
Fixing to the Wall
Page 7
Note: The above installation guideline is for reference only, please contact your local dealer for installation services.
When mounting hood on the wall,the level can be adjusted by turning the two screws on the motor housing.
Installing Guideline
Leveling Device
Page 8
The cooker hood can be installed in the following ways:
Circulating indoor air (A)
Outdoor venting (B)
Page 9
Description of symbols
Using the dial control
- Push the rotary dial, the LED lights will illuminate
- Turning the rotary switch clockwise or counter-clockwise, stop the indicating light at the setting you want to select. The
hood will select that setting after the indicating light illuminates twice.
- Push the rotary switch again at any setting to switch the hood off.
- When the indicator light stops at the ‘timer’ setting, the hood will be functioning at speed III and then automatically switch
off after 3 min.
speed I
speed II
speed III
speed I + light
light
speed II + light
speed III + light
3 min. delay-off at speed III
1. For optimum performance in removing cooking odors, it is recommended that you turn on your range hood prior
to cooking and you leave it operating for 15 minutes after cooking.
2. Clean the surfaces of the range hood regularly using a non-abrasive detergent.
3. The anti-grease filters capture the grease particles suspended in the air. They will accumulate grease and dirt
depending on the frequency of the use of your range/cook top.
4. In order to prevent a fire hazard, it is recommended that you clean the aluminum filter at least every 2 months
Operations
Page 10
Page 11
1. With the grease filter removed, from inside the hood press the light fixture out of its mounting bracket.
.
Emptying and cleaning the fat collector (for models fitted with a fat collector).Emptying and cleaning the fat collector (for models fitted with a fat collector).Emptying and cleaning the fat collector (for models fitted with a fat collector).
Page 12
2. Unplug the light from the wiring harness. Avoid direct contact between the lense an
your
hands.
Then replace the new one.
3.Push the light into its mounting bracket
Page 13
Page 14
610mm from the stove
Page 15
Warranty and Service
Domestic Warranty – Full three year warranty
In addition to all statutory rights which you, the Purchaser, have under relevant laws in respect of
this appliance, during the first three years of ownership as the original purchaser of this Kleenmaid
appliance, Compass Capital Services trading as Kleenmaid guarantee that any fault caused by
defective material or workmanship becoming apparent will be rectified free of charge with reference
to parts and labour, provided that all service is performed during normal working hours by Kleenmaid
or their designated Agents. Where the appliance is installed outside the normal servicing area of the
above, the Purchaser must pay for the cost of transporting the appliance to and from the Agent or the
Agent’s travel cost to and from the purchaser’s home.
Commercial Warranty – One year warranty
When this appliance is installed in a commercial application, in addition to all statutory rights which
you, the Purchaser, have under relevant laws in respect of this appliance, during the first one year of
ownership as the original purchaser of this Kleenmaid appliance, Compass Capital Services trading as
Kleenmaid guarantee that any fault caused by defective material or workmanship becoming apparent
will be rectified free of charge with reference to parts and labour, provided that all service is performed
during normal working hours by Kleenmaid or their designated Agents. Where the appliance is installed
outside the normal servicing area of the above, the Purchaser must pay for the cost of transporting the
appliance to and from the Agent or the Agent’s travel cost to and from the purchaser’s home.
What these warranties do not cover
Compass Capital Services trading as Kleenmaid is not responsible for any damage or malfunction
unless caused by a defect in material or workmanship. This includes but is not limited to abuse,
misuse, improper installation and transportation damage. Compass Capital Services trading as
Kleenmaid is not responsible for consequential damages from any malfunction.
This warranty does not cover wear or breakage of consumable items such as door seals , replacement
of light globes or glass breakage due to impact. In case of fractured glass do not use your appliance.
Purchaser’s responsibility
The Purchaser must make the appliance available for servicing and shall bear any costs incurred
for any de-installation and/or re-installation required to make the appliance available for servicing.
Compass Capital Services trading as Kleenmaid is not liable for any consequential damage incurred
during de-installation or re-installation.
Warranty registration and Proof of Purchase.
Please complete warranty details below and retain together with your proof of purchase document.
When requesting service under this warranty the Purchaser agrees that Proof of Purchase of their
Kleenmaid appliance will be necessary in order to make the warranty valid. Inability to provide Proof
of Purchase even though this warranty is in place will not bind Compass Capital Services trading as
Kleenmaid to repair the appliance at no charge under this warranty and will require the Purchaser to
pay for the service costs in full.
Model Number Date of purchase
For service assistance visit
www.kleenmaidhelp.com.au
Page 16
Compass Capital Services Pty Limited
trading as Kleenmaid
ABN 96138214525
Level 2, 204 Botany Road
Alexandria NSW 2015
E: help@kmaid.com.au
www.kleenmaid-appliances.com.au
Other products available in the
Kleenmaid range of appliances
|
Washing machines
|
Clothes dryers
|
Dishwashers
|
Ovens
|
Cooktops
|
Steam ovens
|
Microwave ovens
|
Built in espresso
coffee machines
|
Rangehoods
|
Freestanding ovens
Loading...