Kleenmaid CH17 User Manual
COOKTOP
c o l l e c t i o n
Instructions for Use
and Warranty Details
Ceramic Cooktops
CH17 - Ceramic Touch Control 600 mm
CH18 - Ceramic Touch Control 780 mm
C
ongratulations on the purchase of your
new Kleenmaid appliance.This appliance
has been designed and manufactured to
give you years of reliable performance.
For best results, carefully read the
instructions on how to install your new appliance. Correct
installation will avoid delays and unnecessary service calls.
Once installation is complete, read this booklet and get to
know the controls and the features of your new appliance.
If you need further information call our
Customer Care Centre
1300 652 100
We reserve the right to alter the specifications with no
influence on the operation of the appliance.This instruction
manual cannot be reason for claim.
CONTENTS
General description ............................................................ 2
Description of sensors ........................................................ 3
Description of timer...............................................................4
Operating
....................................................................... 5,6,7,8
Safety ........................................................................................... 9
Considerations........................................................................ 9
Using pans .............................................................................. 10
Cleaning ................................................................................. 11
Installation ................................................................. 12,13,14
Wiring Diagram..............................................................15,16
Warranty and Service.........................................................17
WARNING
1
• Repair of any fault in your hob must be carried out only by an
Authorized Repair Agent, otherwise the guarantee is not
valid.
• The technical details and identification of the appliance are
shown on the specifition plate.
Consult this plate before proceeding with electrical
connection.
• Electrical connection must be carried out by a specialist
familiar with the laws and official regulations governing such
installation in your State.
2
GENERAL DESCRIPTION
DOUBLE HOTPLATE
....
..
....
....
MODEL
CH17
MODEL
CH18
Control
sensors
Control
sensors
DOUBLE HOTPLATE
3
DESCRIPTION OF SENSORS
MODELS: CH17 and CH18
Double hotplate control point
Double hotplate sensors
Hotplate pilot light
Selected power display
Residual heat display
Power sensors
from 0 to 9
from 9 to 0
Blocking sensor
ON/OFF
Blocking control point
DESCRIPTION OF TIMER
The double hotplate is equipped with a minute timer (1 to
99) that automatically switches off the heat and sounds an
alarm at the end of the selected time.The double hotplate
can operate with or without programming.
Setting the timer
Touch the sensor +/- sensor for the clock to set
numbers of minute duration required. To change the
timer rapidly, keep your finger on the +/- sensor.
Warning function
When the double hotplate is not switched on, the timer
operates as a warning. If the double hotplate is switched
on after pre-selection has been made,it also acts as a
warning.When the set time has elapsed it will give a
warning signal which can be switched off by operating
one of the sensors.
Stopping the program
Touch the sensor until the minute display reaches 00.
Operation of timer
With the double hotplate active, if a specific time is preselected, it will act as a timer and switch off the double
hotplate once this time has elapsed. An audible signal will
advise that the time has expired.
Switch off the warning by operating one of the sensors.
Note:
When operating as a timer, the pilot light switches on 00.
When operating as a warning, the light does not switch on.
Display and sensors
4
MODEL-CH-18
Loading...