KleanTouch VS-HS-15-250CT User Manual

SAFETY DATA SHEET

1. Product and Company Identification:

Mai n Use: Hand Sanitizer
Company: Valisa Manufacturing LLC
Farm ingdale, NY 11735

Telephone: [phone]

Revision Date: April 30, 2020

2. Hazards Identification:

Product Name: kleantouch .05 fl oz single use

131 Executive Boulevard

Signal word: Warning

Flammable Liquid, Category 3
Eye Irritation, Category 2A

Hazard Statements:

H226 Flammable liquid and vapor
H319 Causes serious eye irritation

Precautionary Statements

Prevention:
P210 Keep away from heat/sparks/open flames/hot surfaces. -No smoking.
P233 Keep container tightly closed.
P241 Use explosion-proof electrical/ ventilating/ lighting/ equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P264 Wash skin thoroughly after handling.
P280 Wear protective gloves/ eye protection/ face protection.

Response:
P303 + P361 + P353IF ON SKIN (or hair): Take off immediately all contaminated clothing.
Rinse skin with water/shower.
P305 + P351 + P338IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing.
P337 + P313If eye irritation persists: Get medical advice/ attention

.

Version A Page 1 of 8

Storage:
P403 + P235 Store in a well-ventilated place. Keep cool.
Disposal:
P501Dispose of contents/ container to an approved waste disposal plant.

Other hazards: Vapors may form explosive mixture with air.

3. Composition/ Information on Ingredients:

Mixture: Hazardous Ingredients

Ethyl alcohol CAS 64-17-5 70%
May contain trace amounts of: 2-propanol (CAS 67-63-0), 2-propanol, 2-methyl (CAS 75-65-0),

acetaldehyde (CAS 75-07-0), methanol, (CAS 67-56-1)

4. First Aid Measures:

Eyes: This product may cause irritation. Remove contact lenses, if present and easy to do.

Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician if irritation
persists.

Skin: This product may cause irritation. Wash irritated areas thoroughly with water and soap.
Consult a physician if irritation persists.

Inhalation: This product may cause irritation. If irritation occurs, discard product and remove
individual to fresh air. Consult a physician if irritation persists.

Ingestion: Remove any material remaining in the mouth. Rinse mouth with water. Give water
to drink. Call a physician or Poison Control Center. Do not induce vomiting unless advised by a
physician.

Most important symptoms and effects, both acute and delayed: Causes serious eye irritation.

5. Fire- Fighting Measures:

Suitable extinguishing media: Water spray, Alcohol-resistant foam, Dry chemical, carbon

dioxide.

Unsuitable extinguishing media: High volume water jet.
Specific hazards during firefighting: Do not use a solid water stream as it may scatter and

spread fire. Flash back possible over considerable distance. Vapors may form explosive
mixtures with air. Exposure to combustion products may be a hazard to health.

Hazardous combustion products: Carbon oxides

Version A Page 2 of 8

Specific extinguishing methods: Use extinguishing measures that are appropriate to local
circumstances and the surrounding environment. Use water spray to cool unopened
containers. Remove undamaged containers from fire area if it is safe to do so. Evacuate area.

Special protective equipment for fire-fighters: In the event of fire, wear self-contained
breathing apparatus. Use personal protective equipment.

6. Accidental Release Measures:

Personal precautions, protective equipment and emergency procedures:

Remove all sources of ignition. Use personal protective equipment. Follow safe handling
advice and personal protective equipment recommendations.

Environmental precautions: Discharge into the environment must be avoided.
Prevent further leakage or spillage if safe to do so. Prevent spreading over a wide area (e.g. by
containment or oil barriers) .Retain and dispose of contaminated wash water. Local authorities
should be advised if significant spillages cannot be contained.

Methods and materials for containment and cleaning up: Non-sparking tools should be
used. Soak up with inert absorbent material. Suppress gases/vapors/mists with a water spray
jet. For large spills, provide diking or other appropriate containment to keep material from
spreading. If diked material can be pumped, store recovered material in appropriate container.
Clean up remaining materials from spill with suitable absorbent. Local or national regulations
may apply to releases and disposal of this material, as well as those materials and items
employed in the cleanup of releases. You will need to determine which regulations are
applicable.

7. Handling and Storage:

Technical measures: See engineering measures under EXPOSURE

CONTROLS/PERSONAL PROTECTION section.
Local/Total ventilation: Use with local exhaust ventilation. Use only in an area equipped with

explosion proof exhaust ventilation.
Advice on safe handling: Do not breathe vapors or spray mist. Do not swallow. Do not get in

eyes. Avoid prolonged or repeated contact with skin. Handle in accordance with good industrial
hygiene and safety practice. Non-sparking tools should be used. Keep container tightly closed.
Keep away from heat and sources of ignition. Take precautionary measures against static
discharges. Take care to prevent spills, waste and minimize release to the environment.

Conditions for safe storage: Keep in properly labeled containers. Keep tightly closed. Keep
in a cool, well-ventilated place. Store in accordance with the particular national regulations.
Keep away from heat and sources of ignition.

Materials to avoid: Do not store with the following product types: Strong oxidizing agents,
organic peroxides, flammable solids, pyrophoric liquids, pyrophoric solids, self-heating
substances and mixtures, substances and mixtures which in contact with water emit flammable
gases, explosives gases.

Version A Page 3 of 8