4 channel headphone amp
STEP
STEP
STEP
1
1 Connect external power supply if your
2 Connect CAT5e/CAT6 network cable to
STEP
4
Connect (stereo) audio stream from sound
CONNECT DEVICE
network does not oer Power over Ethernet (PoE)
KLANG:quelle and to your computer
or Dante enabled product/network
Mixing Console
Output Card
Gigabit Ethernet
External Power
Supply 24V DC, 1A
ROUTING TECHNICAL DATA
source to KLANG:quelle Out Left and
2
If you have another Dante enabled product
(e.g. mixing console) proceed with STEP 3.
Otherwise, your computer can also stream audio.
1 OPEN klang.com/dante
2 Install Dante Virtual Soundcard
3 Open DVS and click on START
4 Set DVS as your default sound card
5 Start your DAW or audio player
STEP
5
Connect your headphones and adjust the
Gain Select Switch.
ENJOY LISTENING
Right.
Volume Control
Dante Controller
Ch 01
Ch 02
SOURCE
KLANG:quelle
Out1 Left
Out1 Right
Out2 Left
Out2 Right
Ch 03
In-Ears: -12 or 0dB | Other: 0 or +12dB.
© KLANG:technologies GmbH, Aachen, Germany, 2018. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means—electronic, mechanical, photocopy, recording, or otherwise—without written permission by
KLANG:technologies GmbH | Wespienstr. 8-10 | D-52064 Aachen, Germany. +49 241 89 03 01 22 – support@KLANG.com – www.KLANG.com
SOURCE
audio signals
Gain Select Switch
Output Level Meter
3
1 OPEN klang.com/dante
2 Install & Start Dante Controller
4 Turn o WiFi on your computer
3 Go to ROUTING tab and double click on
your sound source. Go to DEVICE
CONFIG tab and choose preferred
sampling rate. Close this window.
4 Now, do the same for KLANG:quelle and
use the same sampling rate.
Note: Dante devices can only be connected if they
run at the same sampling rates! (default: 48kHz)
STEP
6
WARNINGS AND PRECAUTIONS
Do not remove covers. Connect only to main sockets outlets with protective earth.
Do not handle power cords with wet hands. Do not expose to water or other types of
liquids or moisture (rain, fog, dew etc.). Operating temperature: 0 °C to 50 °C (32 °F
to 122 °F). Do not expose to heat sources.
COMPLIANCE
KLANG:quelle has been tested and found to comply with the requirements defined
in: EN55103-1:2009 EN 55103-2: 2009. EN 55022:2006 / CISPR 22:1997
CAN/CSA-CEI/IEC CISPR 22:02 FCC 47 CFR, Part 15.
SAFETY
UL 60065, 7th Edition, Rev.: 09/21/2012;
CAN/CSAC22.2 No. 60065:03 (R2012).
RoHS Compliant and Pb-Free.
WEEE – RECYCLING
According to RL2002/96/EG (WEEE – Directive on Waste Electrical and Electronic
Equipment) electronic equipment has to be recycled and does not belong in the
standard waste. If you are unsure how to recycle this product please contact us and
we will recycle the device for you.
DIMENSIONS, WEIGHT, POWER
Weight: 0.9 kg
Size (W/H/D): 12 / 4.5 / 19 cm
Max. Voltage +20 dBu at 0 dBFS, Max. channel current 130 mA
Max. Power 25 dBm, Output impedance < 0.1 Ohm
CONTROLLER
030118
Loading...