KJB DVR250 User Manual

Using the Motion-Activated AC Adapter DVR

1. Plug DVR into wall outlet as shown in illustration in
Powering DVR section.

2. Factory default setting is set to record files with a 30 second
file length. If motion lasts longer than 30 seconds, video
clips will be split into 30 second files.

3. DVR will start recording automatically when DVR is plugged in.

4. DVR also will start recording after unit has been plugged in 4. DVR also will start recording after unit has been plugged in
whenever motion is detected.

Viewing and Retreiving Video Footage

1. Video files are stored on SD memory card.

2. To view video, remove SD card from DVR unit.

3. Insert SD card into a card reader or SD card slot in your PC.

4. Computer detects the storage device and user may then browse
and operate the storage device as a typical directory (ie.
Rename, copy, paste, delete, etc).

NOTE:
Every video file is recorded with a
30 second file length. This is a fixed
setting and cannot be changed or
modified.

DVR250

Motion-Activated

AC Adapter DVR

1. The AC Adapter DVR is not battery powered, rather, it is
powered by the two-prong wall outlet.

2. To power the DVR, plug it into wall outlet as shown below.

3. DVR will start recording automatically when motion is detected.

The DVR can also be plugged into an extension cord, so that you
can adjust the viewing angle.