KJB Digital Picture Frame User Manual

8 1

SLUETHGEAR COVERT

DIGITAL WIRELESS

PICTURE FRAME

WITH RCA RECEIVER

2 7

Congratulations and thank you for purchasing the Dig

ital

Picture Frame Hidden Camera!

This newly designed fully functional Digital Picture Frame is

equipped with a completely undetectable, high quality camera

and comes with a 2.4 GHZ receiver

Additional features include:

300 - 700 foot line-of-sight (LOS) approximate range
(LOS is dependent upon obstructions and interference from other wireless devices
High resolution camera
Low light capabilities
Easy installation
User-friendly operation
FCC-approved 2.4 GHz transmitter

Upon reading through these instructions, you will be able to operate your state-of-the-art
Hidden Camera even if you have never before used a covert video surveillance system.

This is primarily a surveillance device; due to the electronics installed you might experience interference when
using the AM/FM radio functions. This is not a defect and is not deemed a warranty issue. Please select
another station if a clearer signal is desired.

NOTICE: In accordance with United States Codes, this unit is not equipped with audio capabilities.
It is illegal for non-authorized persons to own, possess, or utilize surreptitious listening devices for
the purpose of intercepting and/or recording another person’s oral communications. Any modifica­tions made to this unit are unauthorized and will immediately void the manufacturer’s warranty.

Frequently Asked Questions and Trouble Shooting

I

do not get a picture what do I do?

Be sure that the Hidden Camera unit is plugged into a 110V power outlet.

See pairing instructions on page 4 and re “pair” the receiver with the transmitter.

Check your connections. Make sure they are all properly attached and that your
video jack is plugged into the input and not the output and check to see that your
TV or VCR is on the video setting

My signal strength is low how do I fix the problem?

Consider the position of the camera in relation to the receiver and adjust the an-
tenna on the receiver to face the direction of the camera.

Reposition the camera or the receiver to a different location

What does the “QLT” button do on the front of the receiver?

QLT refers to the image quality. With the switch to the left your camera quality is
320 x 240, with the switch to the right the quality is 640 x 480

*Please note that a higher quality picture, depending on placement of the devices
may slow down the frame rate.

**Please note that plugging this unit into any electrical outlet other than a 110V
will cause the unit to not function and voids the warranty on this unit, Please use
correct adapters for your voltage.

3 6

S

etup

Place the Picture Frame Camera on a flat surface fac

ing your target area.
When determining the best possible site selection, pay particular attention to
lighting. It is always best to have the lighting on or in front of your subject
instead of behind it.

Plug the supplied ac adapter (for the picture frame) into the picture frame then
into the nearest 110V AC outlet (120 Volt, 60Hz ONLY)

Position the receiver within 300 ft (see LOS) of the covert camera.

Plug the included ac adapter into the (1) black power cable on the receiver
and then plug into an 110v Ac outlet

Plug either of the yellow (2) RCA male jacks into your TV / Monitor’s Yellow
input, be sure you have selected the necessary input channel to display the video.

Once this is done you should have a picture. If you do not see Page 4 for “paring
instructions”

You are ready to view and or record what your Hidden Covert camera is viewing

1

2