KitchenAid YKERC607HS6, YKERC607HP6, YKESC307HT6, YKESC307HW5, YKESC307HW6 Installation Guide

O

O ®

|

HOME

APPLIANCES

Installation Instructions

o Injury Hazard

Injury from ranges tipping
could result.

See Installation Instructions.

Part No. 9752179

IMPORTANT:
Read and save

these instructions.

IMPORTANT:
Installer: Leave Installation Instructions with the

homeowner.

Homeowner: Keep Installation Instructions for future

reference.

Save Installation Instructions for local electrical

inspector's use.

" (76.2 cm)

ectric ide-in

with self=cleaning

therrnallconvection oven

ange

Cabinet opening dimensions

25" (63.5 cm) countertop

Before you start...

Read electrical and carpentry

instructions.

24" (61 cm) base ..

I _ I clearance to the top

J 30" (76.2 cm) rain. of the cooktop, see

_ __ cabinet opening width J. ***

I 1/2" (1.3 cm)

18" (45.7 cm) (67.6 cm)

upper cabinet opening depth
to countertop

radius both

30=3/8" (77.2 cm)

I

4" (10.2 cm) rain.
clearance to side wall J \

or other combustible
material -- both sides

of range.

Important: Observe
all governing codes

and ordinances,
Earthed-grounded

electrical outlet is
required.

Cabinet opening
dimensions that are

shown must be used.

I

7/8" (2.2 cm)

_. -_min. required

between
cutout and

cabinet door
or hinge.

36" (91.4 cm)
countertop

height

Countertop preparation

width

Earthed outlet -

8" (20.3 cm) to
22" (65.9 cm) from

either cabinet,
7" (!7.8 cm) max.

from floor.

*** Note: 24" (61 cm) min. when bottom

of wood or metal cabinet is protected
by not less than 1/4" (0.64 cm) flame

retardant millboard covered with not
less than No. 28 MSG sheet steel,

0.016" (0.4 ram) stainless steel, 0.024"
(0.6 ram) aluminum or 0.020" (0.5
ram) copper.

30" (76.2 cm) min. clearance between
the top of the cooking platform and
the bottom of an unprotected wood

or metal cabinet.

Do Not pinch the
power supply cord

between the range
and the wall.

Do Not seal range
to side cabinets.

Proper installation is your responsibility, A

qualified technician must install this range.

Make sure you have everything necessary

for correct installation, It is the customer's

responsibility to make sure that the

countertop has been properly prepared and
that the installation clearances specified on
the model/serial rating plate are met. The

model/serial rating plate is located on the
frame behind the drawer,

Check location where range will be

installed. The range should be located for

convenient use in the kitchen, Recessed

installations must provide complete
enclosure of the sides and rear of range,

ALL OPENINGS IN THE WALL OR FLOOR
WHERE RANGE IS TO BE INSTALLED

MUST BE SEALED.

Cutout shown is for a 25-inch (63,5 cm)

countertop with a 24-inch (61 cm) base

cabinet and no backsplash. If countertop has
a backsplash, see "Countertop preparation,"

Cabinet construction: This appliance is
designed for use in a base cabinet with a
depth of 24 inches (61 cm). The maximum
depth for overhead cabinets is 13 inches

(33 cm). For the minimum vertical clearance

between the cooking surface and the
overhead cabinets, see Note,*** Overhead

cabinets installed at either side of the
appliance must be a minimum of 18 inches

(45,7 cm) above the cooking surface, The

minimum horizontal distance between the
overhead cabinets is 30 inches (76,2 cm).

The cooktop sides of the slide-in range fit
over the cutout edge of your countertop.

If you have a square finish (flat)
countertop and the opening width is 30-
3/8" (77.2 cm), no countertop preparation
is required,

Formed front-edged countertops must
have molded edge shaved flat 1/4" (0,64
cm) from each front corner of opening,

Tile countertops may need trim cut back

1/4" (0,64 cm) from each front corner

and/or rounded edge flattened.

width

30-7/8"

(76.4 cm)

,_/J Formed or tiled countertoptrimmed 1/4" (0.64 cm)

back at front corners of
countertop opening.

If countertop opening width is greater
than 30-3/8" (77.2 cm), adjust the 1/4"
(0.64 cm) dimension.

Countertop must be level. Place level on
countertop, first side to side; then front to
back. If countertop is not level, range will

not be level. Oven must be level for
satisfactory baking conditions.

22-6/8"

(67.6cm)

cooktop depth_

64 cm)

Cooktop sides
of range fit

over edges of
countertop

opening.

Injury Hazard

To eliminate the risk of burns or fire,
avoid installing cabinet storage above

the cooking surface. If cabinets are
already installed, reduce the hazard of

reaching over a heated cooking surface
by installing a range hood.The range

hood should extend a minimum of 5
inches out from the bottom front of the
cabinets.

Reaching over a heated cooking
surface could result in a serious burn

or other personal injury.

Note: The metal chassis of the range MUST

be earth-grounded in order for the control

panel to work, If the metal chassis of the

range is not earth-grounded, NO keypads will
operate. Check with a qualified electrician if

you are in doubt as to whether the metal

chassis of range is earth-grounded.

Product dimensions

30-7/8"

1-!/2" cooktop

(3.8 cm) width

(2.5

cm)

(76.4 cm)

26-3/4"

(65.4 cm)
depth

handle

36 '_

(9! .4 cm)

countertop

height

30" (76.2 cm)

width

When installed in a 24" (61 cm)
base cabinet with 25" (63.6 cm)
countertop -- front of oven door
protrudes 1-7/8" (4.8 cm) beyond

base cabinet.

Mobile home installation

The installation of this range must conform to
the Manufactured Home Construction and

Safety Standards, Title 24 CFR, Part 3280

(formerly the Federal Standard for Mobile

Home Construction and Safety, Title 24, HUD,

Part 280); or when such standard is not
applicable, the Standard for Manufactured

Homes Installations (Manufactured Home

Sites, Communities and Setups), ANSI
A225.1/NFPA 501A, or with local codes*.

In Canada, the installation of this range must

conform with the current standards

CAN/CSA-Z 240 -- latest edition**, or with

local codes.
When this range is installed in a mobile home,

it must be secured to the floor during transit.
Any method of securing the range is
adequate as long as it conforms to the

standards listed above.

Four-wire power supply cord must be used in
a mobile home installation. The appliance
wiring will need to be revised.

Copies of the standards listed may be obtained from:

* National Fire Protection Association

Batterymarch Park
Quincy, Massachusetts 02269

** Canadian Standard Association

178 Rexdale Boulevard
Rexdale (Toronto), Ontario Mgw 1R3

Panel A