KitchenAid Gas cooktop, Recreational Vehicle Two-Sealed-Burner Gas Cooktop Installation Instructions Manual

HOME APPLIANCES

Installation Instructions

Recreational Vehicle

Two-Sealed-Burner

Gas Cooktop

IMPORTANT:
Read and save these
instructions.

Important:
Installer: Leave Installation Instructions with the
vehicle owner.
Vehicle Owner: Keep Installation Instructions for
future reference.
Save Installation Instructions for local electrical
inspector’s use.

Part No. 3186562 Rev. A

‘ORTANT:

Observe

all

governing
codes and ordinances. Failure to meet
codes and ordinances could lead to

Minimum cabinet width

fire or electrical

shock.

above one cooktop -12”.
Minimum

cabinet width

cabinets

cabinet to countertop

2

Do Not seal
cooktop to
countertop.

A cu\--

3” min. countertop space to
side wall or other
combustible surface

cord between

Wall B as line opening ­5” be ow countertop

0

and centered with
cooktop.

I I

Outlet - 12” max.

\
from right side
of cookto .

P

15” max. rom

n

bottom of
countertop.

Y

Your safety and the safety of others is very important.

We have provided many important safety messages in this
manual and on your appliance,, Always read and obey all
safety messages.

q

!

This is the safety alert symbol. This symbol

alerts you to hazards that can kill or hurt you
and others. All safety messages will be preceded by the
safetv alert svmbol

and the word “DANGER” or

You will be killed or seriously injured if you don’t follow

I

instructions.

You can be killed or seriously injured if you don’t follow
instructions.

All safety messages will identify the hazard, tell you how to
reduce the chance of injury, and tell you what can happen
if the instructions are not followed.

WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.

- Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.

-WHAT TO DO IF YOU SMELL GAS

l

Do not try to light any appliance.

l

Do not touch any electrical switch.

l

Do not use any phone in your

building.

l

Immediately call your gas supplier
from a neighbor’s phone. Follow the

gas supplier’s instructions.

l

If you cannot reach your gas

supplier, call the fire department.

- Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.

Check location where cooktop will be installed.

Before you start...

Proper installation i’ your responsibility. Make

The location should be away from strong draft

sure you have everything necessary for correct
installation. It is the responsibility of the installer
to comply with the installation clearances

areas, such as windows, doors and strong

specified on the model/serial rating plate. The
model/serial rating plate is located on the bottom

heating vents or fans. The cooktop should be

of cooktop.

located for convenient use in the kitchen.
ALL OPENINGS IN THE WALL OR FLOOR

WHERE COOKTOP IS TO BE INSTALLED
MUST BE SEALED.

Grounded electrical outlet is required. See
Electrical requirements.

Do Not obstruct flow of combustion and
ventilation air.

Proper gas supply connection must be
available. See Gas supply requirements.

30” min. base cabinet is required. If cabinet has
a drawer, a 3-l/2” depth clearance from the
countertop to the top of the drawer (or other
obstruction) in base cabinet is required.

Product dimensions
The distance to the front edge of the countertop,
distance to a side wall or other combustible
surface, location of electric supply and height to
cabinets above cooktop are specified on page 2.

Cabinet construction: This appliance is
designed for use in a base cabinet with a depth
of 24”. The maximum depth for the overhead
cabinets is 13”. The minimum vertical clearance
between the cooking surface and the overhead
cabinets is 30”.

Overhead cabinets installed at either side of the
appliance must be a minimum of 18” above the
cooking surface. The minimum distance
between the front edge of the countertop and the
front edge of the cook-top is 314”. The minimum
horizontal distance between overhead cabinets
above appliances is 30”.

It is the customer’s responsibility:

l To contact a qualified electrical installer.
l To assure that electrical installation is

adequate and in conformance with National
Electrical Code, ANSVNFPA 70 - latest
edition*, and all local codes and ordinances

When installing a cooktop under existing cabinets
and the installation does not meet the minimum
cabinet clearances, install a range hood above

Countertop opening dimensions that are
shown must be used. Given dimensions provide

the cook-top to avoid burn hazards.

required clearances.

Important: Observe all governing codes and
ordinances. Failure to meet codes and
ordinances could lead to fire or electrical
shock.

Copies of the standards listed may be obtained from:

* National Fire Protection Association

Batterymarch Park
Quincy, Massachusetts 02269

Product/cutout Dimensions

\( 11-15116” 4

backsplash
or rear wall

l-1/2” min

*i& 11” ,\

d

1-W” min.

I

front edge
of countertop

3