KitchenAid P1FB6S1 Installation Guide
Installation
Instructions
produce preserver
STARTER KIT
CAUTION: IRRITANT
Do not mix with cleaning products containing ammonia, bleach or acids. Do not get in eyes, on skin or clothing. Do not breathe dust.
Keep out of reach of children.
FIRST AID TREATMENT Contains potassium permanganate. If swallowed, call a Poison Control Center or doctor immediately.
Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse with water.
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM WHEN MIXED WITH OTHER PRODUCTS.
INSTALLING YOUR PRODUCE PRESERVER IS AS EASY AS A-B-C!
A. Install Produce
Preserver Pouches
1. Remove both FreshFlow™
Produce Preserver
pouches from outer
packaging.
2. Open the housing by
pulling back on the
top lip.
3. Insert both pouches
for optimal performance
and snap the
housing closed.
B. Install Status Indicator
1.
Place indicator facedown
on a firm flat surface.
2.
Press the bubble on the
back of the indicator
to activate.
3.
Slide the tab on top of the
housing to the left and place
indicator inside facing out.
4.
Close the tab and make
sure the indicator is visible.
NOTE: Cap will not close
easily if the indicator has
C. Install the
Produce Preserver
1. Clean and dry the area
where the Produce
Preserver will be installed
in the crisper.
2. Remove paper backing
from tape on the rear
of housing.
3. Press and hold housing
evenly against the wall of
crisper for 5 seconds.
not been activated.
Disposable pouches and status indicator should be replaced EVERY 6 MONTHS,
when the indicator has changed completely from white to red.
To replace Produce Preserver, remove pouches and status indicator
and follow directions in the previous sections.
MONTHS
REPLACE
MONTHS
To order
replacements:
®Registered trademark/™Trademark of Whirlpool, U.S.A. ©2011. All rights reserved. Manufactured for
Whirlpool Corporation by Kemflo International (Pingtung, Taiwan, 900). Made in Taiwan. WPX12699
www.whirlpool.com/accessories
1-800-901-2042
W10477761
Loading...