KitchenAid KUDH03DTBL, KUDH03DTSS, KUDH03DTSS1 Dimension Guide

®
23³⁄₈"
(59.4 cm)
19
¹⁄₄"
(48.9 cm)
1
¹⁄₂"
(3.8 cm)
24"
(
61 cm)
33³⁄₄"
(85.7 cm)
23¹⁄₂"
24"
(61 cm)
33³⁄₄"
(85.7 cm)
(59.7 cm)
A
2
8
NOTE: All holes should be drilled at 1½" (3.8 cm) diameter.
A. Choose left-hand or right-hand drain and water connection route. B. Choose left-hand or right-hand electric connection route.
A
B
25"
(63.5 cm)
1/2"
(1.3 cm)
8"
(20.3 cm)
Drawer Dishwasher
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
KUDH03DT
Electrical: 120-volt, 60-Hz, AC-only, 15- or 20-amp fused electrical supply. Use copper wire only. A time-delay fuse or circuit breaker and separate circuit is recommended.
W
pressure. Water temperature must be 120°F (49°C) at dishwasher. Use flexible stainless steel braided fill line (1/2" [1.3 cm] minimum plastic tubing not recommended).
Drain Requirements: Use the new drain hose supplied with your dishwasher. If this is not long enough, use a new drain hose with maximum length of 12' (3.7 m) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher.
Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter, or be connected to an air gap.
Use a drain air gap if the drain hose is connected to house plumbing lower than 20" (50.8 cm) above the subfloor or floor.
Use 1/2" (1.3 cm) minimum I.D. drain line fittings.
CUTOUT DIMENSIONS
PREFERRED UTILITY AREA
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10216167
02-17-09
Loading...