® Drawer Dishwasher
PRODUCT MODEL NUMBERS
KUDD03ST
Electrical: 120 volt, 60 Hz, AC only, 15or 20-amp. fused electrical supply. Use copper wire only. A time-delay fuse or circuit breaker and separate circuit is recommended.
Water: A hot water line with 20-120 psi (138-862 kPa) water pressure. Water temperature
must be 120°F (49°C) at dishwasher. Use 3/8" O.D. copper tubing with compression fitting or flexible stainless steel braided fill line (1/2" minimum plastic tubing not recommended).
Drain: Use the new drain hose supplied with your dishwasher. If this is not suitable, use a new drain hose with a maximum length of 12 feet (3.7 m) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher. Must have a high drain loop 20" (50.8 cm) above the subfloor or floor. Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. An air gap must be used if the drain hose is connected to house plumbing lower than 20"
(50.8 cm) above subfloor or floor. Use 1/2" (1.3 cm) minimum I.D. drain line fittings.
OVERALL DIMENSIONS
24" |
23³⁄ " |
(61 cm) |
(62 cm) |
17" (43.2 cm)
19¹⁄ "
(48.9 cm)
CUTOUT DIMENSIONS
23¹⁄ "
(59.7 cm)
17" (43 cm) Min. 18¹⁄ " (47 cm) Max.
24" (61cm)
PREFERRED UTILITY AREA
¹⁄"
(1.3 cm)
8" (20.3 cm)
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10155577A |
Instructions packed with product. Specifications subject to change without notice. |
03-20-08 |
|