KITCHENAID KRSC 9010, KRSC 9011 Assembly instructions

KRSC 9010
KRSC 9011

Assembly instructions

501910200330_INST_GB_Sbs.qxp 20-11-2007 15:21 Pagina 1

501910200330_INST_GB_Sbs.qxp 20-11-2007 15:21 Pagina 2

Water connection 4

Electrical connection 4

Refrigerator levelling 5

Installation dimensions and requirements 6

Removing the freezer door (A) 7

Removing the refrigerator door (B) 7

Fitting the freezer door (C) 8

Fitting the refrigerator door (D) 8

Horizontal alignment of freezer and refrigerator door (E) 9

Vertical alignment of freezer and refrigerator door (F) 9

501910200330_INST_GB_Sbs.qxp 20-11-2007 15:21 Pagina 3

4

Earthing of the appliance is compulsory by law.
The type of current and the mains voltage to which
the appliance is connected must correspond to that
given on the rating plate.
The connection socket must be accessible even
after installation, so that the appliance can be
unplugged if necessary.
If this is not possible, connect the appliance to the
mains by means of a two-pole switch, with contact
opening distance of at least 3mm, located in an
accessible place.
If the power cable plug and socket are not of the
same type, replace the socket.
Do not pull the power cable when unplugging the
appliance.

Electrical connection

Disconnect your refrigerator from the power
supply before starting the operation.

• Make sure to comply with the current local

regulations regarding connection to the water
system.

• The appliance is supplied with a water pipe
(2.330 m. long) already connected to the back
of the product.

• Remove the packing tape from the grey coiled
water pipe on the back of the product.

• Connect the transition connector (I) to the
household water supply (2).

• Make sure the water pipe is not twisted.

• Open the water tap and check for and eliminate

any leaks.

• The appliance does not require adjustments or
a water drain.

Water connection

501910200330_INST_GB_Sbs.qxp 20-11-2007 15:21 Pagina 4