KITCHENAID KHYD1 38510 User Manual
Instructions for use
Installation diagrams |
4 |
Important safety instructions |
6 |
Safeguarding the environment |
9 |
Declaration of conformity |
9 |
Before use |
9 |
Existing pots and pans |
9 |
Recommended pot bottom widths |
9 |
Installation |
10 |
Electrical connection |
10 |
Instructions for use |
11 |
After-Sales Service |
16 |
3
Installation diagrams
4
Installation diagrams
1 |
N.B. For the Semifilo version, |
|
|
|
61 |
it is not necessary to lower |
||
|
|
the hob by 1.5 mm. |
|
||
|
|
|
|
||
R |
380 |
|
R |
+1 |
|
|
12 |
381 |
0 |
||
11 |
|
|
|
|
|
|
|
|
+1 |
|
|
510 |
|
|
0 |
|
|
|
|
511 |
|
|
|
|
|
|
|
360 |
+1 |
|
|
|
|
0 |
|
1.5
+1 490 0
FRONT |
INDUCTION |
INDUCTION |
AIR |
|
AIR |
SEAL SEALANT
SEAL SEALANT 
5
These instructions shall also be available on website: www.kitchenaid.eu
IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety messages, to be read and always observed.
This is the danger symbol, regarding safety, warning of potential risks to users and others.
All safety messages will be preceded by the danger symbol and the following words:
DANGER
WARNING
Indicates a hazardous situation which, if not avoided, will result in serious injury.
Indicates a hazardous situation which, if not avoided, could cause serious injury.
All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance.
Make sure to comply with the following:
-Use protective gloves to perform all unpacking and installation operations.
-The appliance must be disconnected from the power supply before carrying out any installation operation.
-Installation and maintenance must be carried out by a specialised technician, in compliance with the manufacturer’s instructions and the local safety regulations in force. Do not repair or replace any part of the appliance unless specifically stated in the user manual.
-The appliance must be earthed.
-The power cable must be long enough for connecting the appliance, fitted in the cabinet, to the power supply.
-For installation to comply with the current safety regulations, an omnipolar switch with minimum contact gap of 3mm is required.
6
Loading...