KitchenAid KHTU160KWH0 Warranty Guide

7

Warranty

KitchenAid®Range Hood Warranty

LENGTH OF WARRANTY KitchenAid WILL PAY FOR

LIMITED ONE-YEAR WARRANTY Labor and any parts of your range hood (except light bulbs and
From Date of Purchase filters) which are defective in materials or workmanship.

KitchenAid WILL NOT PAY FOR

A. Consumable parts such as light bulbs and filters.

B. Service calls to:

1. Correct the installation of the range hood.

2. Instruct you how to use the range hood.

3. Replace house fuses or correct house wiring.

C. Repairs when range hood is used in other than normal, single-family household use.

D. Pickup and delivery. This product is designed to be repaired in the home.

E. Damage to range hood caused by accident, misuse, fire, flood, act of God or use of products not approved

by KitchenAid.

KITCHENAID AND KITCHENAID CANADA DO NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. Some states or provinces do not allow the exclusion or limitation of incidental or

consequential damages, so this exclusion or limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to
state or province to province.

Outside the United States and Canada, a different warranty may apply. For details, please contact your
authorized KitchenAid dealer.

If you need service, see the “Requesting Assistance or Service” section or call our KitchenAid Customer
Interaction Center, 1-800-235-0665 (toll-free), from anywhere in the U.S.A. or Canada.

Care of range hood

remove screw

Filters: For best results, remove

and clean aluminum filters often.
Filters can be cleaned in a
dishwasher or with hot sudsy
water.
Do not wash charcoal filters used
with non-vented (recirculating)
installations. Charcoal filters can
be replaced by ordering Kit Part
No. 4396273, available from your
dealer.

To remove filters: Pull the
deflector down. Push the handles
toward the back of the hood and
pull down.

Replacing lights:

Use a Phillips screwdriver to
remove screw holding the light
lens cap. Remove the bulb and
replace with a 40W, E17 sfera,
120-volt type bulb. Reinstall light
lens.

Cleaning grease collection cup:

Twist cup counterclockwise to
remove. Wash in hot sudsy water.
Dry, insert into opening and twist
clockwise.

Exterior surfaces: Clean with a
mild detergent and soft cloth. DO
NOT use abrasive cleaners or
steel wool.

grease

collection

cup

deflector

To reinstall filters: Insert filters

into back of hood; push up into
place while pushing back on
handles. Release handles.