KITCHENAID KHRT 6010/I User Manual

Instructions for use

Before using the glass ceramic hob 4

Installation 4

Electrical connections 6

Energy saving tips 7

Safeguarding the environment 7

Precautions and general recommendations 8

Hob accessories 9

Care and maintenance of the glass ceramic hob 9

Troubleshooting guide 10

After Sales Service 10

• To make the most of your new appliance, please read the user instructions carefully and keep them
handy for future consultation.

Before using the glass ceramic hob

Hob

• The Hob has to be set into a worktop between 20 – 50mm
deep.

• Do not place any material between the cooktop and oven
(cross beams, brackets, etc.)

• The distance between the lower face of the glass ceramic
hob and the cupboard or separating panel must comply
with the sizes shown in figure “A”.

• If a column cabinetry unit has to be installed next to the
cooktop, leave a distance of at least 100mm from the edge
of the cooktop.

Cut out the hole in the work surface to the dimensions shown in
the enclosed description sheet.
Clean the work surface, then apply the gasket around the
underneath of the hob (unless it has already been installed).

Important

In order to prevent the electronic circuits overheating and becoming
damaged, we recommend the following:

• Do not install the hob near a dishwasher, or washing
machine as steam or moisture could damage the electronic
controls.

If an oven is installed beneath the cook top (from our range of
ovens), make sure it is equipped with a cooling system.
If the temperature of the electronic circuits exceeds the maximum
permitted temperature, the hob will automatically switch off; if this
happens, wait a few minutes until the electronic circuits cool down,
at which point it will be possible to turn the hob on again.

• Turn the hob off after use.

Installation

4

Front

Rear wall