KITCHENAID KHID3 65510 User Manual

Instructions for use

3

Installation diagrams 4

Important safety instructions 6

Safeguarding the environment 9

Declaration of conformity 9

Before use 9

Existing pots and pans 9

Recommended pot bottom widths 9

Installation 10

Electrical connection 10

Instructions for use 12

Cleaning 15

Troubleshooting guide 15

Noises made by the hob 15

After-Sales Service 16

Power level table 16

4

Installation diagrams

210 mm 280 mm

145 mm

5

Min. 10 cm

Min. 3 cm
Max. 6 cm

Installation diagrams

3

21

X4

580
650
700 mm

52 mm

483 mm

510 mm

553 mm

0

+1

30 mm

560 mm

0

+2

490 mm

Max. 8 mm

Min. 50 mm

0

+2

R = Min. 6,5 mm

Min. 5 mm

6

YOUR SAFETY AND THAT OF OTHERS IS VERY
IMPORTANT

This manual and the appliance itself provide important safety messages,
to be read and always observed.

This is the danger symbol, regarding safety, warning of potential

risks to users and others.
All safety messages will be preceded by the danger symbol and
the following words:

Indicates a hazardous situation which, if
not avoided, will result in serious injury.

Indicates a hazardous situation which, if
not avoided, could cause serious injury.

All messages relevant to safety specify the potential risk to which they
refer and indicate how to reduce the risk of injury, damage and electric
shocks due to incorrect use of the appliance.

Make sure to comply with the following:

- Use protective gloves to perform all unpacking and installation
operations.

- The appliance must be disconnected from the power supply before
carrying out any installation operation.

- Installation and maintenance must be carried out by a specialised
technician, in compliance with the manufacturer’s instructions and the
local safety regulations in force. Do not repair or replace any part of
the appliance unless specifically stated in the user manual.

- The appliance must be earthed.

- The power cable must be long enough for connecting the appliance,
fitted in the cabinet, to the power supply.

- For installation to comply with the current safety regulations, an
omnipolar switch with minimum contact gap of 3mm is required.

WARNING

DANGER

IMPORTANT SAFETY INSTRUCTIONS

These instructions shall also be available on website: www.kitchenaid.eu