[] []
{;
Readandsa e these
IMPORTANT:
Installer: Leave installation
Instructions with the homeowner.
Homeowner: Keep Installation
Instructions for future reference.
Save Installation Instructions for local
electrical inspector's use.
I_itchen_kid _
FORTHE WAY IT'S MADE _°
Write down the model and serial numbers
before installing warming oven.
Both numbers are on the model/serial
rating plate, located on the upper left front
corner of the oven cavity.
Model #
Serial #
Questions regarding features, operation,
performance, parts or service? Call
1o800o422ol230 or visit our web site at
www.kitchenaid.com.
Call when you:
[] Have questions about warming oven
installation or operation.
[] Need to obtain the name and number
of an authorized service
company.
When you call, you will need:
[] The warming oven model number.
[] The warming oven serial number.
Both numbers are listed on the
model/serial rating plate, located on the
upper left front corner of the oven cavity.
Part No. 4452828
Before youstart...
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
symbol.This symbol alerts
1_ This is the safety alert
you to hazards that can kill
or hurt you and others. All safety
messages will be preceded by the
safety alert symbol and the word
"DANGER" or "WARNING". These
words mean:
You will be killed or seriously
injured if you don't follow
instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will identify the
hazard, tell you how to reduce the
chance of injury, and tell you what
can happen if the instructions are
not followed.
[mportant: Observe aH governing
codes and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this
oven.
Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.
Cabinet opening dimensions that are
shown must be used. Given dimensions
provide minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See
"Electrical requirements."
Etectrica_ supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If
the electrical outlet is located in an
adjacent cabinet, provide a 1o3/8"dia.
minimum power supply cord plug
clearance hole in the back of the cutout or
support surface.
Oven support surface MUST be solid,
level and flush with bottom of cabinet
cutout.
There is no provision to level the oven
after it has been installed, if the
installation is not level, the door may
slide open or not seal tightly allowing
heat to escape resulting in poor oven
performance.
mtis the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with
National Electrical Code, AN$I/NFPA 70
E latest edition*, and all local codes and
ordinances.
Copies of the standards _isted may be obtained
from:
* Nationa_ Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
Toolsneededfor installation: Partssupplied:
screwdriver
PNHips
/