KitchenAid KEWD105HBL05, KEWD105HWH05, KEWD175HBT1, KEWD175HSS06, KEWD175HWH1 Installation Guide

...
[] []
Readandsa e these
IMPORTANT: Installer: Leave installation
Instructions with the homeowner. Homeowner: Keep Installation
Instructions for future reference. Save Installation Instructions for local
electrical inspector's use.
I(itchen_kid _
FORTHE WAY IT'S MADE
Write down the model and serial numbers before installing warming oven.
Both numbers are on the model/serial rating plate, located on the upper left front
corner of the oven cavity. Model #
Serial #
Questions regarding features, operation, performance, parts or service? Call
1o800o461o5681or visit our web site at
www. kitchenaid.com/ca nada.
Call when you: [] Have questions about warming oven
installation or operation.
[] Need to obtain the name and number
of an authorized service company.
When you call, you will need: [] The warming oven model number. [] The warming oven serial number.
Both numbers are listed on the model/serial rating plate, located on the
upper left front corner of the oven cavity.
www.kitchenaid.comlcanada 1-800.461-8681
Part No. 8300561
Before youstart,,,
Your safety and the safety of others are very important,
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the
word "DANGER" or "WARNING". These words mean:
You can be killed or seriousJy
injured if you don't immediately
follow instructions.
You can be killed or seriously
injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the
instructions are not followed.
important: Observe aJJ governing
codes and ordinances, Proper installation is your responsibility.
Have a qualified technician install this
oven,
Oven location should be away from strong draft areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given dimensions
provide minimum ciearance. Recessed installation area must provide
complete enclosure around the recessed portion of the oven.
Electrical ground is required. See "Electrical requirements."
Electrical supply outlet should be located in the rear wall on the lower right side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If the electrical outlet is located in an
adjacent cabinet, provide a 1o3/8"dia. minimum power supply cord plug
clearance hole in the back of the cutout or support surface.
Oven support surface MUST be solid, level and flush with bottom of cabinet
cutout. There is no provision to level the oven
after it has been installed, If the installation is not level, the door may
slide open or not seal tightly allowing heat to escape resulting in poor oven
performance.
It is the customer's responsibility: To contact a qualified electrical installer,
To assure that the electrical installation is adequate and in conformance with
National Electrical Code, ANSI/NFPA 70
E latest edition*, or CSA Standards
022.1-94, Canadian Electrical Code, Part 1 and 622 No, 0-M91 E latest edition** and
all local codes and ordinances,
Copies of the standards listed may be obtained
from:
* NationaJ Fire Protection Association
One Batterymarch Park Quincy, Massachusetts 02269
e* Canadian Electrical Association
178 Rexdale BouJevard Etobicoke {Toronto), Ontario MSW 1R3
Toolsneededfor Partssupplied:
screwdriver
Phillips
/
Loading...
+ 4 hidden pages